4.26 FL (Model 14.1 XGA Toshiba)
4
4.26 TFT FL (Model 14.1 Toshiba)
Removing the TFT FL (Model 14.1 Toshiba)
To remove the TFT FL (Model 14.1 Toshiba), follow the steps below and refer to figures
4-59 to 4-63.
1. Carefully, turn the LCD module upside down on the flat surface of the table. To avoid
damaging the surface of the LCD module, lay it on a protective, dust-free sheet such
as a soft, clean cloth.
2. Remove one strip of insulation tape "1" securing the FL cable, two strips of insulation
tape "2".
3. Remove one strip of insulation tape "3" securing the X-PCB insulation sheet and one
strips of insulation tape "4" securing Y-PCB insulation sheet.
4. Lift up the X-PCB insulation sheet and the Y-PCB insulation sheet. Be careful to lift
up only the part that covers the back of the LCD module. Hold down the frame as you
lift the insulation sheets. (Do not lift up the part of the sheet on the side of the frame.
X and Y-PCB insulation sheets will be reused.)
CAUTION: Do not damage the X-PCB, Y-PCB and FPC.
Insulation tape "1"
Figure 4-59 Removing the insulation tape and sheet
TECRA 9100 Maintenance Manual (960-347)
Insulation tape "3"
Insulation tape "4"
Insulation tape "2"
4 Replacement Procedures
4-89