Parameterizing Using The Parameterizing And Start-Up Tool Simocom U; Installing Simocom U - Siemens SIMODRIVE 611 universal Function Manual

3 Parameterizing the Board
3.3 Parameterizing using the parameterizing and start–up tool SimoCom U
3.3 Parameterizing using the parameterizing and start–up
tool SimoCom U
3.3.1

Installing SimoCom U

Prerequisite
Software supply
Which SimoCom U
version is the
optimum one?
3-96
Note
"SimoCom U" is a tool that is used for commissioning, diagnostics and
parameterization. It is not permissible to use this tool as operator
interface for continuous operation of drives!
A PG/PC is required to install the tool; it must fulfill the following mini-
mum requirements:
S
Operating system:

Windows 98 or Windows NT
from SW 4.1 also Windows ME
from SW 6.1, also Window XP
S
32 MB RAM memory
S
Free memory required on the hard disk
– Installing with one language ––>
– Installing each additional language ––>
S
1 free serial interface (RS232 interface)
The various software versions are supplied on a CD–ROM.
Further, the software is available in the Internet under the following ad-
dress:
http://www.ad.siemens.de/
––> Products & Solutions ––> Drive systems ––> Drive converters ––>
SIMODRIVE 611 ––> 611 universal ––> Downloads
The "SimoCom U" parameterizing and start–up tool can be used for
various drives.
The functional scope of "SimoCom U" tool will be continually adapted to
the functional expansion of these drives.
In order to parameterize and handle all of the functions of a drive using
"SimoCom U", the optimum matching "SimoCom U" must be used, de-
pending on the drive software release.
Reader's note
Which version of SimoCom U optimally matches which drive and which
drive software release?
refer to SimoCom U as follows:
Help ––> Info about "SimoCom U" ... ––> Versions
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition

or
 
or Windows 2000 or

30 MB
plus approx. 10 MB
E Siemens AG 2005 All Rights Reserved
06.04 10.04 01.99