Before You Begin; Prerequisites; A Look At The Sample Program - HP 64793 Series User Manual

Before You Begin

Prerequisites

A Look at the Sample
Program
2-2 Getting Started
Before beginning the tutorial presented in this chapter, you must have
completed the following tasks:
1. Connected the emulator to your computer. The HP 64700
Series Installation/Service manual show you how to do this.
2. Installed the Softkey Interface software on your computer.
Refer to the HP 64700 Series Installation/Service manual for
instructions on installing software.
3. In addition, you should read and understand the concepts of
emulation presented in the Concepts of Emulation and
Analysis manual. The Installation/Service manual also covers
HP64700 system architecture. A brief understanding of these
concepts may help avoid questions later.
You should read the Softkey Interface Reference manual to
learn how to use the Softkey Interface in general. For the
most part, this manual contains information specific to the
H8/338 emulator.
The sample program used in this chapter is listed in figure 2-1. The
program emulates a primitive command interpreter. The sample
program is shipped with the Softkey Interface and may be copied from
the following location.
/usr/hp64000/demo/emul/hp64793/cmd_rds.src
Data Declarations
The "Table" section defines the messages used by the program to
respond to various command inputs. These messages are labeled
Msg_A,Msg_B, and Msg_I.