Related Manuals for Rockler Router Table Box Joint Jig
Summary of Contents for Rockler Router Table Box Joint Jig
- Page 1 Router Table Box Joint Jig Instructions Effective January 2018 Review full manual instructions prior to use for important safety information. Always check Rockler.com to confirm that you are using the most recent manual version for your product.
-
Page 2: General Safety Warnings
This product is designed for specific applications as defined in the instructions and should not be modified and/or used for any other applications. Before using the Router Table Box Joint Jig, read, understand and follow all instructions and safety information provided. - Page 3 PRODUCT SPECIFIC SAFETY WARNINGS > To avoid serious injury, keep hands and fingers away from rotating cutter. > Use only with wood and MDF no more than 1" thick. > Maintain control of the Sled and workpiece at all times by holding workpiece securely or clamping the workpiece to >...
-
Page 4: Parts List
PARTS LIST Quantity Quantity Platform 1/4" Indexing Key Five-star Knob 3/8" Indexing Key Washer 1/2" Indexing Key 10 MDF Sacrificial Fence Expandable Miter Bar 11 1/4"-20 Machine Screws Miter Bar Bolt 12 1" Panhead Screws Sled... - Page 5 Fig. 1 Fig. 2 Setup 1. Assemble the jig, but leave off the MDF Sacrificial THESE WARNINGS PERTAIN Fence (7) for now. TO ALL REMAINING STEPS: Store the Indexing Keys that aren’t being used in the onboard compartments incorporated in the Sled. >...
- Page 6 To avoid risk of serious injury and damage to the jig, never set the bit cutting height more than 1" above the surface of the jig Platform (1). If you have a router lift on your table, you might need to drill a hole in the Platform (1) to be able to access the adjustment mechanism.
- Page 7 Label each piece on the inside face (A, B, C and D) and mark the top and bottom edges (T and B). Fig. 6. The Router Table Box Joint Jig is intended 2. To make the first cut, position the top edge of for use in cutting end-grain joints like those shown.
- Page 8 Fig. 8 6. To make the cuts in workpieces C and D, follow the process outlined in Steps 2-5. Check Rockler.com for updates. If you have further questions, please contact our Technical Support Department at 1-800-260-9663 or support@rockler.com Fig. 9 Fig.
Need help?
Do you have a question about the Router Table Box Joint Jig and is the answer not in the manual?
Questions and answers