Set Configuration Parameter - Dormakaba ED250 Installation Instructions Manual

dormakaba ED250 IG Installation Instructions

21.2 Set configuration parameter

21.2.1 Parameter AS, installation type.
Parameter AS set during initial spindle rotation
for hanging door (Para. 16.15.2).
21.2.2 Set parameter rd, reveal depth.
Step 1
Press and hold right button greater
Press
than 3 sec. to enter parameter mode;
AS parameter displayed.
Step 2
Press
Scroll to rd parameter.
Step 3
Press
Displays "00" , factory setting.
Step 4
Press
"00" starts flashing.
Step 5
Press
If required, scroll to select parameter
different parameter value.
Step 6
Press Saves value entered.
Display stops flashing.
Step 7
Press
Returns to reveal depth parameter.
TIPS AND RECOMMENDATIONS
Reference Chapter 18 for reveal depth
parameter values.
68 ED250
3 Four button keypad
4 Two digit display
21.2.3 Set parameter Tb, door width.
Step 8
Press
Step 9
Press
Step 10
Press
Step 11
Press
Step 12
Press
Step 13
Press
Step 14
Press
TIPS AND RECOMMENDATIONS
Reference Chapter 17 for door width
parameter values.
21.2.4 Parameter dL, door type.
TIPS AND RECOMMENDATIONS
Parameter dL factory setting is 0, single door.
Reference Chapter 22 for double door
commissioning.
DL4614-070
Chapter 21
Fig. 21.2.1 4 button keypad,
2 digit display
< 3s Quit
> 3s Reset
> 3s
PRG
> 3s
3
< 3s
LEARN
> 8s
Fact-Setup
Scroll to Tb parameter.
Displays "10" , factory setting.
"10" starts flashing.
Scroll to select parameter value.
"7" shown as example.
Saves value entered.
Display stops flashing.
Returns to door width parameter.
If single door, exit program mode
(Step 14).
Exits parameter mode. Display
indicates "ready for learning cycle".
4
08-2018