Panasonic AG-CX7 Operating Instructions Manual page 41

@ NOTE
0 Do not erase a folder or file on the memory card with a computer. It may make it impossible to load on the unit.
0 If data is recorded to the memory card with a computer, an error may occur such as an inability to recognize or record to the memory card with the unit.
0 The memory card to use with the unit should always be formatted on the unit.
(For the )
CX10
0 When transferring a recording data in a P2 format to a computer, or when writing back to a microP2 card, be sure to use the dedicated software "P2
Viewer Plus" to prevent data loss. For details on downloading P2 Viewer Plus and the operating environment, visit the support desk at the following
website:
https://pro-av.panasonic.net/en/products/ag-cx10/index.html
0 Follow the instructions below when using a general IT tool such as the OS standard file manager equipped on a computer to transfer a recording data in
P2 format to a computer. However, be sure to use P2 Viewer Plus when returning data back to a microP2 card.
j Perform the transfer for each CONTENTS folder and LASTCLIP.TXT file.
j Do not operate the folders under the CONTENTS folder.
j When copying, copy the LASTCLIP.TXT file at the same time as the CONTENTS folder.
j When transferring the data in multiple microP2 cards to a computer, create a folder for each memory card to prevent clips with the same name from
being overwritten.
j Do not delete data inside a memory card.
j Be sure to format the memory card with a P2 device or P2 Viewer Plus.
Volume label of the memory card
∫ When the file format is MOV or MP4
The value set in the [RECORDING] menu → [CLIP NAME] is stored in the volume label in the CAM INDEX i NEXT CARD COUNT format when the
memory card is formatted. Once it is stored, [NEXT CARD COUNT] will increase by one. The CARD COUNT that is stored is also used for the CARD
number of the MOV format/MP4 format file name.
@ NOTE
0 When recording to the memory card that CAM INDEX i CARD COUNT is not stored in the volume label, the value set in the [RECORDING] menu →
[CLIP NAME] is automatically stored in the volume label, and [NEXT CARD COUNT] will increase by one.
∫ When the file format is P2
The card serial number is stored in the volume label if the card being used is the microP2 card. "CAM_SD" is stored in the volume label if a card other
than the microP2 card is used.
* Available for setting when using
Folder name of the MOV format/MP4 format video data
The fourth through eighth characters of the folder name differ depending on the setting of the unit.
1
Folder number
001 to 999 (sequential number)
2
Number of pixels
R: 3840×2160
Y: 1920×1080
3
Frame rate
A : 59.94 fps
B : 50.00 fps
C : 29.97 fps
D : 25.00 fps
F : 23.98 fps
4
Video format
P : Progressive recording (MP4, AAC)
Q : Progressive recording (MOV, LPCM)
I : Interlace recording (MP4, AAC)
J : Interlace recording (MOV, LPCM)
5
Fixed values
A
6
Recording setting
M : Standard recording (card slot 1 for simultaneous recording)
T : Simultaneous recording (card slot 2 for simultaneous recording)
7
Recording format information
Chapter 3 Preparation — Preparing the memory card
*
or AVCHD
.
CX10
0
1 2 3 4 5 6
0 1 R A Q A M
7
- 41 -