Data Stream; View Freeze Frame; I/M Readiness - Sealey VS8812 Instructions Manual

5.3.

Data Stream

the View data function allows viewing of live or real time PId data of vehicle's computer module(s).
1) use the ScroLL button to select data Stream from diagnostics menu and press the enter button. If there is no freeze frame data
available, an advisory message "no data Stream!" shows on the display.
the number "x" to the right of the screen indicates sequence of display. Wait a few seconds while the scan tool validates
the PId mAP.
3) If retrieved information covers more than one screen, use the ScroLL button, as necessary.
4) Press enter button to return to previous screen.
5.4. View Freeze Frame Data
freeze frame data allows the technician to view the vehicle's operating parameters at the moment a dtc (diagnostic trouble code)
is detected. for example, the parameters may include engine speed (rPm), engine coolant temperature (ect), or vehicle speed
sensor (VSS) etc. this information will aid the technician by allowing the parameters to be checked for diagnostic and repair
purposes.
1) to view freeze frame data, use the ScroLL button to select View freeze frame from diagnostic menu and press the enter
button.
2) Wait a few seconds while the scan tool validates the PId mAP.
3) If retrieved information covers more than one screen, use the ScroLL button, as necessary.
If there is no freeze frame data available, an advisory message "no freeze frame data stored!" shows on the display.
the number "x" to the right of the screen indicates sequence of display.
the red navigation bar to the right of the screen indicates sequence of highlighted item.
4) Press enter button to return to previous screen.
5.5.

I/M Readiness

I/m readiness function is used to check the operation of the emission System on eoBd compliant vehicles. It is an excellent
function to use prior to having a vehicle inspected.
CaUTION - By clearing trouble codes you also clear the readiness status for the individual emission system readiness tests. In order
to reset these monitors, the vehicle must be driven through a complete drive cycle with no trouble codes in the memory. times for
reset vary depending on vehicle.
Some latest vehicle models may support two types of I/m readiness tests:
A. Since dtcs cleared - indicates status of the monitors since the dtcs are erased.
B. this drive cycle - indicates status of monitors since the beginning of the current drive cycle.
An I/m readiness Status result of "no" does not necessarily indicate that the vehicle being tested will fail the I/m inspection.
one or more such monitors may be allowed to be "not ready" to pass the emissions inspection.
"oK" - Indicates that a particular monitor being checked has completed its diagnostic testing.
"Inc" - Indicates that a particular monitor being checked has not completed its diagnostic testing.
"n/A" - the monitor is not supported on that vehicle.
1) use the ScroLL button to select I/m readiness from diagnostic menu and press enter button.
2) Wait a few seconds while the scan tool validates the PId mAP.
3) If the vehicle supports both types of tests, then both types will be shown on the screen for selection.
© Jack Sealey Limited
All datastream
fuelsys1
fuelsys2
Load_Pct
ect
Shrtfi1 -64.8%
con.
freeze frame
dtcfrZf P1633
fueLSYS2 --
LoAd_Pct (%) 0.0
ect(c) -40
SHrtft1 (%) 99.2
I/m readiness
Since dtcs Were cleared
this drive cycle
Original Language Version
1/17
cL
----
45.5%
98
1/5
1/2
VS8812 | Issue 1 27/02/17
Page 10