Checking The Battery Capacity - Parkside PAAS A2 Operation And Safety Notes

CAUTION! Do not connect the product to your car's
12 V connection if the car battery is already old and
worn . Doing so could mean that the car engine will no
longer start .
Note: In order to use the product without
a USB cable 12 , you need to recharge the
rechargeable battery before use . The charging
process takes about 3 .5 hours . The rechargeable
battery is firmly integrated into the base of the
product .
Note: Fully charge the rechargeable battery
prior to first use .
Note: Charge the battery if the brightness of the
light becomes weak .
Open the protective cap 7 .
Connect the USB cable 12 with the
USB connector of the power adaptor 10 or the
car charger adaptor 11 .
Connect the micro-USB plug of the USB cable 12
to the micro-USB input socket 8 on the product .
Plug the power adaptor 10 into a socket, or plug
the car charger adaptor 11 into the 12 V socket in
your vehicle .
Note: The green charging indicator 5 will light
up and flash during charging . There are 4 indicator
lights showing the charging progress (approx . 25 % /
50 % / 75 % / 100 %) . When the indicator
continually light on mean the represented charging
progress was finished . When charging is complete, all
indicator light up without flashing . The charging time is
approximately 3 .5 hours when batteries are drained .
Note: The product has an overcharging protection
system . Nevertheless, you should disconnect the
product from the mains once the charging process is
complete .
Disconnect the USB cable 12 from the product to
prevent the batteries discharging themselves .
Close the protective cap 7 before you start to
use the product again . Otherwise water could
enter to the product when it is used at outdoors .
˜ Checking the battery capacity
When product is not charged: Press the battery status
button 6 to check the battery capacity . The green
charging indicator 5 shows the capacity of the
power bank inside the product .
1 LED lights up =
2 LEDs light up =
3 LEDs light up =
4 LEDs light up = 100 %
Note: * This is the approximate percentage of
battery capacity but not actual measurement .
˜ Operation and use
m RISK OF ACCIDENT! Preferably do not use the
product whilst driving the vehicle . When using
the product in a vehicle, be sure this does not
endanger the driver or the passengers . Always
store and secure the product so that even full
braking does not pose a risk of injury from the
product or product damage .
Turn the adjustable foot / hand grip 4 and fix the
product at desired position . The adjustable foot /
grip can also turning up to approximately 180º
and use as a hand grip .
The product may be secured by securing it to a
flat, ferromagnetic surface using the magnet 2 at
the back .
m CAUTION! Please note the position of your
hands whilst turning the adjustable foot / hand
grip 4 to prevent pinching your fingers .
The product may be used as a light and a charger .
Both functions can also be used simultaneously .
25 %
50 %
75 %
GB/IE 19