Polygroup Summer Waves Maintenance Kit Owner's Manual page 3

8. Remove the canister top cover of the SFX or SFS Series Skimmer pump.
SFX
10. Put the vacuum adapter over the strainer and press downward.
A vacuum will be generated that will keep the vacuum adapter in place.
SFX
12. Keeping the hose end underwater, slowly slip the end of the hose
through the skimmer opening and attach the end of the hose to
the vacuum adapter's hose connection.
SFX
14. A vacuum is now generated from the vacuum head all the way to the filter cartridge.
15. Slowly push the vacuum head across the pool to remove debris. Check the water flow at the return fitting while vacuuming.
16. When the water flow from the return fitting is noticeably reduced, the filter cartridge is likely to be partially clogged. Turn off the pump, remove the filter
cartridge and gently brush/rinse under running water. Replace with a new cartridge if necessary. Repeat the process until the pool is thoroughly cleaned.
IMPORTANT NOTE: For vacuuming with other Polygroup
Please follow the directions on page 4 of this manual.
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8 AM to 5 PM Mon. thru Fri.
SFS
SFS
SFS
Filter Pump Systems; Models: CP2000-C, RP, RX and Sand Filtration Systems;
®
MST. Extended operating days and hours during peak season requirements.
OWNER'S MANUAL
9. For Summer Waves SFX Skimmer Pump, remove the wier from the canister.
For Summer Waves SFS Skimmer Pump, flip the wier away from the canister.
SFX
11. Place the open end of the flexible hose up to the return fitting and start to fill the
hose with water. Keep filling the hose until there is no more air inside the hose.
13. Hand tighten the hose clamp.
SFX
SFS
SFS
3