Residual Risks; Package Contents; Assembly And Adjustments - DeWalt DE7025 Original Instructions Manual

EN GLI SH
• DO NOT use the stand on uneven
surfaces. The stand is designed to be
used on a flat, stable, non-slippery
surface.

Residual Risks

In spite of the application of the relevant safety
regulations and the implementation of safety
devices, certain residual risks cannot be avoided.
These are:
– Risk of personal injury by sharp edges and
squeezing .
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual before use.
Wear eye protection.

Package Contents

The package contains:
2 Mitre saw mounting brackets
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fi g. 1)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
a. Mounting brackets
b. Release levers
c. Non-marring feet
INTENDED USE
Your mounting brackets have been designed to
extend the versaltility of your D
DO NOT use under wet conditions or in presence of
flammable liquids or gases.
These mounting brackets are professional power
tools.
16
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.

ASSEMBLY AND ADJUSTMENTS

DE7025 D
Method (fi g. 2, 3)
1. Place saw in operational position with blade
2. Place a spacer under one side of the mitre saw
3. Hold a mounting bracket (a) under the saw and
WALT mitre saw.
E
WARNING: Always observe the safety
instructions and applicable regulations.
WALT Mitre Saw Mounting
E
WARNING: To reduce the risk of
injury, turn unit off, disconnect
machine from power source before
assembling the mitre saw to the
mitre saw stand. An accidental start-
up can cause injury.
WARNING: Stability Hazard. You
must use the Universal Mitre Saw
Mounting Method when mounting
a mitre saw not manufactured by
D WALT to this mitre saw stand.
E
WARNING: To reduce the risk of
personal injury, be sure the mitre saw is
fully anchored on the stand.
WARNING: For your own safety,
read and understand the mitre saw
instruction manual before using. Failure
to heed these warnings may result in
personal injury and serious damage to
the mitre saw and the accessory.
facing you. Align with label on the mounting
bracket showing front.
to hold the saw's mounting feet above the work
surface.
feed a carriage bolt (hardware bag) up through
the bracket and the foot of the saw.
NOTE: See DE7025 Hardware Selection
Chart for the correct mounting hardware
procedures for D WALT mitre saws. Follow all
E
instructions properly, otherwise the mitre saw's
table rotation may be obstructed.