Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for ELICA KIT0121468
Summary of Contents for ELICA KIT0121468
- Page 1 White KIT0121468/ Black KIT0121469...
- Page 2 INSTRUCTIONS FOR SAFE OPERATION OF THE REMOTE CONTROL The remote control can be used by children who are younger than 8 years old and by persons with reduced physical, sen- sory or mental capacity, or without experience or the specific knowledge, as long as they are under surveillance or after they have received...
- Page 3 Keys...
- Page 4 white fixed = data transmission red fixed = battery flat red flashing = charging > low power level green flashing = charging > high power level green fixed = battery charged Key pressing methods click held click simultaneous click...
- Page 5 CAUTION! Some functions marked here with an (#) can only be activated on certain hood models. See the operation and maintenance manual for your specific hood for further information. CAUTION! To control the hood via remote control, the a liation procedure must be carried out (see 1 | AFFILIATION).
- Page 6 1 | AFFILIATION Disconnect and then reconnect the hood to the power supply and within the first minute, press keys for 5 seconds. per 5 s NOTE! If a liation is unsuccessful, discon- nect and then reconnect the hood to the power supply and repeat the a liation procedure.
- Page 7 2 | HOOD ON 3 | INCREASE SPEED 4 | DELAYED TIMED SHUT-DOWN (of current speed ) (#) Press for 2 s...
- Page 8 5 | DECREASE SPEED (until hood shuts down) 6 | HOOD OFF (#) Press for 2 s...
- Page 9 7 | LIGHT ON (directed onto hob) 8 | LIGHT REGULATION (directed onto hob) (#) Press key for 2 seconds to start light regulation (directed onto hob). Release the key when the desired lighting condition is achieved. Press > 2 s...
- Page 10 9 | AMBIENT LIGHT ON (#) 10 | AMBIENT LIGHT REGULATION (#) Press key for 2 seconds to start ambient light regulation. Release the key when the desired lighting condition is achieved. Press > 2 s...
- Page 11 11 | LIGHT TONE REGULATION (warm/cold light) (#) Press keys 2 seconds to start light tone regulation. Release the key when the desired lighting condition is achieved. > 2 s 12 | SENSOR ACTIVATION (#)
- Page 12 13 | RESET FILTERS (#) Press for 2 s 14 | NEW CODE ALLOCATION Press for 2 s...
- Page 13 Directive 1999/5/EC. The Declaration of Conformity can be viewed at the following link: http://elica.com/DeclarationOfConfor- mity.pdf CONFORMITY Elica remote control complies with the following requirements: -FCC (Federal Communications Commission) Part 15. Operation is subject to the following two conditions: 1) This device may not cause harmful...
- Page 14 Do not dispose of electrical products in the general waste and ensure the used product or batteries are disposed safely according to your local authority and regulations. Elica via Ermanno Casoli, 2 60044 Fabriano AN Italy T +39 0732 6101 F +39 0732 610249 elica.com...
Need help?
Do you have a question about the KIT0121468 and is the answer not in the manual?
Questions and answers
Can you program more than one remote for the ECEX40SS? I have two remotes but seems to only respond to one. If I affiliate the second remote, the first one stops working and the second will start working