English CROSS-CUT MITRE SAW DWS771, DWS777 Congratulations! EC-Declaration of Conformity You have chosen a D WALT tool. Years of experience, thorough product Machinery Directive development and innovation make D WALT one of the most reliable partners for professional power tool users.
English b ) Do not operate power tools in explosive atmospheres, such as Such preventive safety measures reduce the risk of starting the power in the presence of flammable liquids, gases or dust. Power tools tool accidentally. create sparks which may ignite the dust or fumes. d ) Store idle power tools out of the reach of children and do c ) Keep children and bystanders away while operating a power not allow persons unfamiliar with the power tool or these...
English spinning saw blade while cutting. There should be no nails or foreign • TIGHTEN ALL CLAMP HANDLES, knobs and levers prior to operation. objects in the workpiece. Loose clamps can cause parts or the workpiece to be thrown at high speeds. h ) Do not use the saw until the table is clear of all tools, wood scraps, etc., except for the workpiece.
English • NEVER LOCK THE SWITCH IN THE “ON” POSITION. Severe personal WARNING: 115 V units have to be operated via a fail-safe isolating injury may result. transformer with an earth screen between the primary and secondary winding. • NEVER STAND ON TOOL. Serious injury could occur if the tool is tipped or if the cutting tool is unintentionally contacted.
Page 12
Cable Assembling the Base Extensions (Fig. V) Rotating table Speed control dial WARNING: Base extensions must be assembled to both sides of (DWS771 only) Mitre scale the saw's base before using the saw. Padlock hole Sliding fence WARNING: Be sure to adjust the base extensions using the...
Page 13
English • Before transporting the saw, lower the saw head, loosen the rail lock 7. If adjustment is required, proceed as follows: knob and push the saw head all the way to the back. Press in the 17 a. Loosen the screws 39 and move the scale/mitre arm assembly lock down button ...
Page 14
6. Totally depress the head to allow the blade to cut through the timber Speed Control Dial (Fig. A) and push the head back to complete the cut. DWS771 only 7. After completing the cut, release the switch and wait for the saw blade The speed control dial ...
English 1. Loosen the bevel clamp handle 18 by pulling it outward then down and set the bevel as desired. SQUARE BOX 2. Set the override lever 29 if required. 3. Hold the head firmly and do not allow it to fall. 4. Tighten the bevel clamp handle 18 firmly.
English Optional Accessories efficiency. To restore your saw's dust collection efficiency, depress the spring inside the dust bag when you are emptying it and tap it on the side of the WARNING: Since accessories, other than those offered by D WALT, trash can or dust receptacle.