Setup; Introduction; Invoking Setup - Mitsubishi Electric Apricot LS Pro Using Setup And Installing Add-Ons

SETUP

Introduction

The Apricot LS Pro system board is fitted with a small area
of memory which is used to store information about the
configuration of the computer. The computer's
configuration is modified using a SETUP utility provided in
Read Only Memory (ROM) on the system board.
A rechargeable battery on the system board maintains the
configuration memory when the LS Pro is switched off.

Invoking SETUP

Each time the LS Pro is switched on, or rebooted, it runs
through a self test procedure. During this period the
SETUP utility can be invoked by pressing the + key
ALT S
combination.
The LS Pro can boot in two ways, it can use a graphical
boot screen, or a conventional text based boot screen.
During graphical boot a Setup button is displayed, SETUP
can only be invoked while the button is not greyed out.
During text boot a prompt appears on the screen, while the
prompt is visible SETUP can be invoked.
There may be a delay of a few seconds, while the self test
procedure is completed, before the SETUP screen
appears.
3