LaserPerformance Zuma Rigging Manual

ZUMA
Rigging Manual
Unpacking and preparation
1
2 Assembly
3 Launching
1. Unpacking and preparation
Unpack the major parts listed below and lay them out on a soft piece of
ground free of sharp objects. To avoid damaging contents, do not cut
into packaging.
a. Hull
b. Mast kit which includes:
Top section
Bottom section (larger diameter)
Boom (with blocks attached)
c. Boat kit which includes:
Sail in bag
Tiller
Tiller extension
Batten set
Daggerboard
Rudder assembly
Line bag (all lines are labeled)
d. Block package which includes:
Mainsheet block
Double traveler block
Vang block with v-cleat
Small vang block with becket
Shackle
Note: All lines are as long as necessary for maximum purchase. Vanguard Sailboats
encourages you to customize line lengths for your sailing pleasure, but be sure to cut and
burn ends to prevent fraying.
Useful
knots
to know
FIGURE 8 OR SQUARE KNOT
STOPPER KNOT
Fogh Marine | 416 251-0384 | www.foghmarine.com | info@foghmarine.com
ZUMA
Tools: To rig your Zuma the fi rst
time, you will need the following:
• White electrical tape
• 2 adjustable wrenches and/
or pliers
CLEAT BOWLINE CLOVE HITCH