Tyre Pressure Monitoring System (Tpms) - Mitsubishi ASX 2016 Owner's Manual

To resume the set speed
If the set speed driving is deactivated by the
condition described in "To deactivate" on
page 6-58, you can resume the previously set
speed by push up the RES + switch (C) while
driving at a speed of about 40 km/h (25 mph)
or higher.
Under either of the following conditions,
however, using the switch does not allow you
to resume the previously set speed.
In these situations, repeat the speed setting
procedure:
l The CRUISE CONTROL ON/OFF
switch is pressed.
l [Except vehicles equipped with keyless
operation system]
E00609800675
Turn the ignition switch to the "LOCK"
or "ACC" position.
[Vehicles equipped with keyless opera-
tion system]
Put the operation mode in OFF or ACC.
l
"CRUISE" indication lamp is turned
OFF.
Tyre pressure monitoring
system (TPMS)*
The tyre pressure monitoring system (TPMS)
uses tyre inflation pressure sensors (A) on the
wheels to monitor the tyre inflation pressures.
The system only indicates when a tyre is sig-
nificantly under-inflated.
The base tyre pressure can be set at desired
value by the driver with the reset function ex-
ecution. (The low pressure warning threshold
is set based on the reset.)

Tyre pressure monitoring system (TPMS)*

The tyre inflation pressure sensor IDs for two
sets of tyres can be registered by a
MITSUBISHI MOTORS Authorized Service
Point, and the valid ID set can be switched by
the multi-information meter switch (It's ben-
eficial in case of seasonal tyre change be-
tween summer tyre and winter tyre.)
E00637100165
l
OGAE15E5
WARNING
The spare wheel does not have a tyre in-
flation pressure sensor.
When the spare tyre is used, the tyre pres-
sure monitoring system will not work
properly.
See a MITSUBISHI MOTORS Author-
ized Service Point as soon as possible to
replace or repair the original tyre.
Starting and driving
6
6-59