Installing The Cab Cabling And Auxiliary Input Module - Ag Leader Technology DirectCommand Installation Instructions Manual

DirectCommand
Apache AS715/1010/1210 (MY 2009-2010)
Installing
the Cab
Cabling and
Auxiliary
Input
Module
Step-by-Step for
Installing the
Cab Cabling and
Auxiliary Input
Module
PN: 2005943 Rev. D
Installation
6. Mount the Display in a convenient place for operation, but out of
the operator's line of sight while operating the sprayer.
Parts required for procedure:
From Direct Command Kit:
• (1) Apache Switchbox Adapter
• (1) Power Cable
From Auxiliary Input Module Kit:
• (1) Deutsch Dust Plug – 6-pin
• (1) CAN Y-Splice
• (1) CAN Bus Stub – 1 ft.
• (1) Auxiliary input Module
From Display Kit or Display Cable Kit 4100814
• (1) Power Control Relay
• (1) Display Cable
1. Mount the Auxiliary Input Module, PN: 4000437, behind the
operators seat.
NOTE: Make sure to leave enough room for routing
cables avoiding any pinch points.
2. Connect the round 28-pin connector on the Display Cable, PN:
4001608-12, to the connector on the back of the InSight or EDGE
Display, or the connector labeled MAIN on the back of the
Ag Leader INTEGRA display.
Display Mounting Rail
December 2013
Ag Leader Technology
PN: 4001615
PN: 4002016-5
PN: 2002899-6
PN: 4000137
PN: 4000219-1
PN: 4000437
PN: 4000708-1
PN: 4001608-12
Page 7 of 13