Advertisement
4.1.7
Ensure the keys are fully
inserted.
4.2
THICKNESSING
4.2.1
Remove the set bolt on
the fence seat.
4.2.4
Fasten the set screw.
4.2.7
Remove chute from underneath
table and place on top over blade
5. OPERATING INSTRUCTIONS
WARNING! Ensure you read, understand and apply Section 1 safety instructions before use.
We recommend you check the alignment of cutting bladesbefore use. See section 6.3.7.
5.1
PLANING (Fig.A)
5.1.1
The cutting depth is set by handle (A). Use the front table plate (B) in conjunction with the scale (C) for the cutting depth.
A cutting depth of between 0.5 and 1.5 mm (1/64"~1/16") will produce the best results.
WARNING: The part of the blades not used, must to be covered by the blade guard.
Note! Attach a suitable dust extractor to the dust chute. This reduces the amount of airborne dust and health risks associated with
inhalation of particles.
5.1.2
Take up a working position so that you are always on one side of the machine away from the area directly in front of or behind cutterhead.
5.1.3
Lift STOP cover and push the start button.
NOTE! The STOP button is also the Emergency Stop button. Incase of an emergency hit the STOP button, it will lock into place to prevent the
start button being activated again. The stop button will require unclipping in order to gain access to the start button.
5.1.4
Place both hands on the workpiece. Do not hold the workpiece with your fingers anywhere near the blades.
NOTE! Only plane workpieces which rest firmly on the planer and can be safely guided.
5.1.5
Introduce the workpiece from the feed side. Gently guide the workpiece over the blades. Do not force the workpiece but allow the machine
to do the work.
4.1.8
Chute fully assembled for
planing operations.
4.2.2
Loosen the set screw.
4.2.5
Slide the guard away from
the table.
4.2.8
Locate the two keys on the
chute and align with the
cut-outs on the table and
insert the keys.
C
Fig.A
Note! The SM1311 is fitted with a safety
interlink which prevents the machine from
being used without the chip extractor in place
and the keys inserted.
Reset
SM1311 has a reset button in case of motor
Button
overload. Should the machine stop due to
excessive demands you will need to press the
reset button, shown left.
4.2.3
4.2.6
4.2.9
A
B
Remove fence assembly.
Set the safety guard at
its uppermost position
and fasten the set screw.
Check the keys are fully
inserted.
Note: Guard must cover blades
Advertisement
