Advertisement
Advertisement
Table of Contents
Related Manuals for Huawei SmartAX MA5672
Summary of Contents for Huawei SmartAX MA5672
-
Page 1: Quick Start
SmartAX MA5672 Multi-service Access Equipment Quick Start... - Page 2 Precautions To use the device properly and safely, read the precautions carefully before using the device and strictly observe these precautions when using the device. Security warning and Precautions: Do not look directly into the optical port without eye protection. ...
- Page 3 The equipment needed to be far away from the large heat source, naked fire, and large power equipment, such as electric heater, candles, hair dryer, avoid introducing safety risk. Near power lines - equipment or equipment, such as aging or aging cable plug board and other facilities, please timely replacement, to avoid the introduction of safety risk.
- Page 4 Installing the MA5672 Horizontally placed on a workbench The following figure shows the MA5672 horizontally placed on a workbench. Mounted onto a wall The MA5672 can be mounted horizontally or vertically onto the wall. Step1 Mark the positions of two holes (with a spacing of 150mm) used for mounting the MA5672.
-
Page 5: Connecting Cables
Connecting Cables Cable connections between the MA5672 and Other devices IP set-top box(STB) Power adapter Optical port in the wall Fax machine TV-set Telephone set... - Page 6 Refer to the preceding cable connections of each product and select the following corresponding steps to connect the MA5672. Step1 Use an optical fiber to connect the OPTICAL port on the MA5672 to the optical port in the wall. The optical connector connected to the OPTICAL port is SC/APC. Step2 Use a network cable to connect the LAN port to the Ethernet port of the PC or IP STB.
-
Page 7: Description Of Leds
Description of LEDs Table 4-1 LED status indications 1 Status Description Always on The connection to the voice server is TEL1～TEL4 set up. Blinks quickly (twice per The connection to the voice server is second) set up and the telephone is in the off-hook or ringing state. - Page 8 The connection between the MA5672 and the OLT is not set Blinks quickly The MA5672 is attempting to set (twice per second) up a connection to the OLT. Always on The connection between the MA5672 and the OLT is set up. The Rx optical power of the MA5672 is normal.
-
Page 9: Technical Specifications
Technical Specifications Item Specifications Dimensions (L x W x H) 260mm x 180mm x 30mm Weight 0.843kg Working temperature -40º C - +55º C, the device can be started at -25 ° C. The minimum temperature. Working humidity 5% - 95% (non condensing) -
Page 10: Declaration On Hazardous Substances In Electronic Information Products
Declaration on Hazardous Substances in Electronic Information Products Hazardous Substances Parts Cr6+ PBDE ○ ○ ○ ○ ○ Mechanical part × ○ ○ ○ ○ ○ Board/circuit module × ○ ○ ○ ○ ○ Signal cable × ○ ○ ○ ○... -
Page 11: Warranty Card
Warranty Card Thank you for choosing Huawei Technologies Co., Ltd. To get better services, please read this warranty card carefully, fill in the required information, and preserve this card in good condition. PERSONAL OR COMPANY FULL NAME Address/Postal Code Telephone Number... -
Page 12: Limited Warranty
In any case that is not covered by this limited warranty or should the warranty expire, Huawei shall charge for the service(s) claimed for the products if the product is still remediable. Huawei preserves the right for interpretation of this limited warranty. -
Page 14: Trademarks And Permissions
No part of this document may be reproduced or transmitted in any form or by any means without prior written consent of Huawei Technologies Co., Ltd. Trademarks and Permissions and other Huawei trademarks are trademarks of Huawei Technologies Co., Ltd. All other trademarks and trade names mentioned in this document are the property of their respective holders.