Panasonic MICRO-IMAGECHECKER A200 Series Hardware Manual page 4

Before Switching On the Power
The following points should be checked before switching the power on to the controller
for the first time.
− Check that no extra wiring left installation, especially conductive materials, have
become attached to the board.
− Confirm that the power supply wiring and I/O wiring and power supply voltage are
correct.
− Firmly tighten all installation screws and terminal block screws.
Before Creating Type Data
Before creating type data, be sure to initialize the environment settings and all type
settings.
See User's Manual for more information about initialization.
Other Instructions
− Use monitor, monitor cable, keypad, camera and camera cable models and serial
numbers specified by Panasonic Electric Works Co., Ltd.
− Do not disassemble, modify, or change internal settings for the
Micro−Imagechecker unit or other equipment.
− Setting or changing items other than those that can be set or changed, as
described in the product manual and specifications, will result in damage.
− After completing all of the settings for the Micro−Imagechecker, do not connect
the personal computer used for connecting the keypad, restoring or backup, in
order to prevent malfunctioning due to noise.
− Do not perform insulation resistance or pressure resistance tests between metal
areas of the power supply, input/output signal and connectors and the camera
case.