Reset Specification - Hitachi HIDIC EH-150 Applications Manual

5.6

Reset Specification

To reset this module, execute either of the following procedures.
No. Type
1 Hardware
2 Hardware
3 Software
In this chapter, it mentions about the way of operating the reset function from the user program of the above
No.3 .
To execute the above No.3, the version of EH-CPU and EH-RMD must become as follows.
CPU type
EH-CPU308/316
EH-CPU308A
EH-CPU316A
EH-CPU448
EH-CPU448A
EH-CPU516
EH-CPU548
HARDWARE REV.02 and later
Table 5.9 Reset procedures
Explanation
Turn on this system again.
Push the reset switch of from of the module.
Only EH-RMD is reset.
Operate the reset function from the user program
Only EH-RMD is reset.
Table 5.10 Resetting function supporting EH-CPU
Version
-
ROM VER. A2** ( ** ≥ "00 " )
ROM VER. B2** ( ** ≥ "00 " )
ROM VER. C3** ( ** ≥ "26 " )
ROM VER. C4** ( ** ≥ "08 " )
All version
Table 5.11 Resetting function supporting EH-RMD
Version
Chapter 5 Master Module Specifications
Note
Not supported
Note
mentioned in main name plate
(left side of the module)
5-5