Fig. 8-3: Loosen The Fastening Screws At The Mounting Frame; Fig. 8-7: Loosen The Vsb 40.1 From The Mounting Plate - Bosch Rexroth VSB 40.1 Project Planning Manual

8-6
Maintenance and Installation
Changing the Hard Disk of the VSB 40.1, Variant LS
1. Save all required user data as well as the operating system settings
of your system on an external storage medium or via the network
connection!
2. Shutdown the operating system.
3. Wait until the power supply unit switches off and then, switch off the
supply voltage. If required, unplug all connectors.
4. Put the VSB 40.1 on a solid mat, so that the connector panel looks in
your direction.
5. Loosen the four screws with which the hard disk frame is fixed at the
VSB 40.1:
Fig. 8-6: Loosen the fastening screws at the mounting frame
6. Remove the VSB 40.1 carefully from the mounting plate (mounting
frame), because the hard disk drive is fastened in the mounting
frame.
Fig. 8-7: Loosen the VSB 40.1 from the mounting plate
VSB 40.1
83_LS_Gehäuse.JPG
83_LS_oeffnen.JPG
DOK-SUPPL*-VSB*40.1***-PR01-EN-P