Replacing The Gap Sensor Module - TSC TE200 Series Service Manual

TE200/TE210/TE300/TE310 Series
Bar Code Printer Service Manua
Stepping Motor

3.4 Replacing the Gap Sensor Module

l
5. Disconnect the stepping motor
connectors on the main board.
6. Remove/replace the stepping motor
module.
7. Reassemble the parts in the reverse
procedure.
Steeping motor module
1. Please refer to the
remove the print engine.
2. Turn the print engine upside down
and remove the screw as indicated.
Screw on Gap Sensor
(receiver)
3. Remove/replace the gap sensor
(receiver).
Gap sensor (receiver)
(Fixed position, shift 4 mm to right)
17
section 3.1 to