Port Forwarding - UPC GIGA CONNECT BOX Manual

Port forwarding

The Port forwarding screen lets you forward inbound traffic from the Internet to a
specified device on the network.
Click Create a new rule to set up a new port forwarding rule. The interface prompts
you to set up a new rule. Complete the following fields:
 Local IP: Enter the IP address of the device on the network where you want the
connections to go.
 Local start port: Enter the port at the lower end of the local port range that you
want to forward..
 Local end port: Enter the port at the upper end of the local port range that you
want to forward.
 External start port: Enter the port at the lower end of the external port range that
you want to forward.
 External end port: Enter the port at the upper end of the external port range that
you want to forward.
 Protocol: Specify the protocol that you want to use.
 Enabled: Specify that you want to enable this rule.
When you finish entering this information, click Add rule to return to the Port
forwarding screen.
Once you have finished making changes to the Port forwarding screen, click Apply
changes to save your changes.
Manual Giga Connect Box
37