Figure 89 Connection Example Without A Dedicated Remote Support Port; Figure 90 Connection Example When The Ip Address Of The Slave Cm Is Set - Fujitsu ETERNUS AF250 Design Manual

2. Connection Configuration
LAN Connection
■
Connection Configurations
MNT ports are used for connecting a LAN for operation management.

Figure 89 Connection Example without a Dedicated Remote Support Port

Administration
terminal
IP address A
The following figure provides connection examples for when setting the IP address of the Slave CM.
Figure 90 Connection Example When the IP Address of the Slave CM Is Set (and a Dedicated Remote Support
Port Is Not Used)
Administration
terminal
IP address A
SNMP
E-mail server
manager
LAN switch
CM#0
Controller enclosure
ETERNUS AF
SNMP
E-mail server
manager
Syslog server
LAN switch
LAN for operation management
IP address B
CM#0
Controller enclosure
ETERNUS AF
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays Design Guide (Basic)
Copyright 2019 FUJITSU LIMITED
NTP server
Authentication
Syslog server
server
LAN for operation management
RMT ports are not used.
CM#1
NTP server
Authentication
server
Remote support
center
RMT ports are not used.
The IP addresses of the Master CM
and the Slave CM are set.
CM#1
136
Remote support
center
P3AG-1822-09ENZ0