Philips DCB293/79 User Manual page 15

2
Press / to scroll the menu options:
• [Station list]
• [Full scan]
• [Manual tune]
• [DRC] (dynamic range control)
• [Prune]
• [System]
3
To select an option, press ENTER.
4
Repeat step 2-3 if sub-option is available
under one option.
Full scan
Full scan is used to perform a wide range of
DAB+ radio search.
1
In the DAB+ mode, press MENU to
enter the menu options.
2
Press / repeatedly until [Full scan] is
displayed.
3
Press ENTER to confirm the selection.
»
Full scan starts automatically.
Manual tune
With this feature, you can tune to a specific
channel/frequency manually. In addition to
antenna orientation for better radio reception,
the optimal reception can also be obtained
with this feature.
1
In the DAB+ mode, press MENU to
display the "Manual tune" option.
2
Press ENTER to confirm the selection.
»
The display shows a channel and its
frequency.
3
Press / repeatedly until the desired
channel/frequency appears.
4
Press ENTER to confirm the selection.
Tip
•
You may press DISPLAY to change the service
information on the display.
•
You may adjust the position of the antenna to
obtain the optimal signal strength.
• Press MENU to exit manual tune
function.
16 EN
DRC
Dynamic range control (DRC) adds or
removes a degree of compensation for the
differences in the dynamic range between
radio stations.
• [DRC off] (DRC is switched off.)
• [DRC high] (DRC is switched on; the
default setting recommended for noisy
environment.)
• [DRC low] (DRC is set to half normal
level)
Prune
With this feature, you can clear all the invalid
stations from the station list.
1
In the DAB+ mode, press MENU to
enter the menu options.
2
Press / repeatedly until [Prune] is
displayed.
3
Press ENTER to confirm the selection.
» [Y] or [N] is displayed.
4
Press / to switch between [Y] and
[N].
5
Press ENTER to confirm.
System
With this feature, you can:
• know the software version of the unit
1
In the DAB+ mode, press MENU to
enter the menu options.
2
Press / repeatedly until [System] is
displayed.
3
Press ENTER to confirm.
» [SW version] is displayed.
4
Press ENTER again.
»
The software version of the main unit
is displayed.
• reset DAB/FM stations
1
In the DAB+ mode, press MENU to
enter the menu options.
2
Press / repeatedly until [System] is
displayed.
3
Press ENTER to confirm.
» [SW version] is displayed.