4 Get started
Turn on
1
Press .
»
The unit switches to the last selected
source.
Note
•
If no source is played within 15 minutes, the
unit switches to standby mode.
•
If no operation is performed within 15 minutes
in standby mode, the unit switches to Eco-
power standby mode.
•
Press
to switch the unit to the last source
when it was turned off.
Demonstrate the unit's features
1. In the standby mode, press
ON" is displayed.
»
This system's features are displayed
one by one.
•
To turn off the demonstration, press
again.
Set the clock
The unit uses the 24-hour or 12-hour time
format.
1
In standby mode, press and hold CLOCK
for 2 seconds.
»
"CLOCK SET" scrolls on the display.
Then the time format [24H] or [12H]
appears.
2
Press VOL +/- to select a time format.
Press CLOCK to confirm.
»
The hour digits blink.
3
Press VOL +/- to set the hour. Press
CLOCK to confirm.
»
The minute digits blink.
4
Press CLOCK to confirm the setup.
•
The number key on the RC is deactivated in
this mode.
Adjust brightness of display
panel
1
Turn on or off LED light
1
Store radio stations
automatically
until "DEMO
If no radio stations are stored, the unit can store
radio stations automatically.
1
2
3
Find the correct video input
channel
1
2
Note
Press DIM repeatedly to select different
brightness levels.
In power-on mode, press and hold DIM
to turn on or off the LED light at the
bottom of the unit or at the volume
knob.
Turn on the unit.
Press RADIO.
» [AUTO INSTALL ---- PRESS PLAY
STOP CANCEL] (press
automatic installation, or press
cancel) is displayed.
Press
.
»
The unit automatically stores radio
stations with sufficient signal strength.
»
After all available radio stations are
stored, the first stored radio station is
broadcast automatically.
Turn on your unit.
Press DISC to select the disc source.
•
Turn on the TV and switch to the
correct video-in channel.
to start
to
EN
13