Honeywell PHD6 Quick Reference Card

Hide thumbs Also See for PHD6:

Enlarged version

PHD6 Quick Reference Card

Operation

Procedure

Turn on

Press MODE button.

Hold MODE button until display says "release."

Turn PHD6 on and allow sensors to stabilize. Take

to fresh air. Press MODE 3 times to enter "Auto Cal

Mode." At prompt press MODE to Auto-Zero. At

next prompt press MODE to begin Auto-Span.

Attach calibration adaptor and fittings. Apply span

gas. Remove fittings when complete. If Auto-Zero

or Auto-Span fails see Reference Manual.

01JUNE2011 – Rev. 2.00 – 13-323.doc

Table of Contents

Do you have a question about the PHD6 and is the answer not in the manual?

Page 1 Press MODE button. Turn off Hold MODE button until display says “release.” Turn PHD6 on and allow sensors to stabilize. Take to fresh air. Press MODE 3 times to enter “Auto Cal Mode.” At prompt press MODE to Auto-Zero. At Auto Cal next prompt press MODE to begin Auto-Span.
Page 2 Test Slip pump onto instrument with tubing and probe continuous attached. PHD6 will prompt for leak test. Hold sample finger over end of probe. Pump should shut down. pump Remove finger and press MODE to reset pump.