Siemens SINUMERIK 840 User Manual page 190

07.90
The following parameters must be defined prior to call:
Parameters Description
R08 Extended T address (see Section 2.2)
R09 T number (tool number) (see Section 2.2)
R10 = 0 No automatic tool offset
> 0 Automatic tool offset (see Section 2.2)
R11 = 0 Without empirical and average value
> 0 Empirical value memory number (average value memory for diameter)
(see Section 2.3)
R13 = 0...359.5 Compensation angle position for monodirectional probe (see Section 2.5)
R22 Probe number (see Section 2.6)
R23 = 1 1-point measurement
= 11 1-point measurement with differential measurement
R25 Variable measuring speed in mm/min
R25 = 0 Standard cycle value
R26 = 0...359.5 Start angle (with differential measurement only)
R27 = 1...R Number of measurements at same location (typically 1..3)
max
R28 = 1...R Multiplication factor for measurement path "2a"
max
R29 = 1...R Weighting factor a for averaging (typically 1...3)
max
R30 = 1...3 Number of measuring axis (see Section 2.12)
R33 Zero offset range
R34 Compensation range with averaging
R36 Safe area
R37 Dimensional difference check
R40 Upper tolerance limit
R41 Lower tolerance limit
R42 Set value
See Section 10.2 for result display parameters.
©
Siemens AG 1990 All Rights Reserved
SINUMERIK 840/850/880 (BN)
5 Measuring Cycles for Milling Machines and Machining Centres
6FC5197- AB70
5.4.2 L978 1-point measurement
(according to drawing)
(according to drawing)
(according to drawing)
5–71