Summary of Contents for Ripmax Chris Foss WOT Trainer A-CF001A
Page 1
Sie bitte an oben angegebene Adresse, oder besuchen Sie unsere Webseite unter www.ripmax.de Made in China Manufactured for and distributed to your local model shop by: Ripmax Ltd., 241 Green Street, Enfield, EN3 7SJ. United Kingdom. A-CF001A...
Page 2
Teilen in Berührung kommen! Denken Sie level directly in line with other people/animals as this Ripmax shall not be liable for any loss, consequential loss, damage auch an Ihre Haustiere! Ripmax Produkte sind häufig nur ein Teil einer ganzen will increase the risk of injury.
Page 3
Wot Trainer Instructions | Wot Trainer Anleitung Wot Trainer Instructions | Wot Trainer Anleitung Wot Trainer Instructions | Wot Trainer Anleitung Chris Foss Chris Foss Introduction / Einführung The Designer / Der Designer Congratulations on your purchase of the Wot Trainer EP/GP ARTF! This Wot Trainer is suitable for both electric and I/C power depending on the optional power pack you choose.
Page 4
Wot Trainer Instructions | Wot Trainer Anleitung Wot Trainer Instructions | Wot Trainer Anleitung Stage 1 / Schritt 1 Stage 6 / Schritt 6 Prepare your aileron servo by fitting the rubber grommets Locate the aileron pushrods, plastic clevises and silicon and brass ferrules supplied with the servo.
Page 5
Wot Trainer Instructions | Wot Trainer Anleitung Wot Trainer Instructions | Wot Trainer Anleitung Stage 11 / Schritt 11 Stage 16 / Schritt 16 Cut off any excess pushrod with a pair of side cutter or Slide the wheel onto the axle and fit the collet to the axle, suitable pliers.
Page 6
Wot Trainer Instructions | Wot Trainer Anleitung Wot Trainer Instructions | Wot Trainer Anleitung Stage 24 / Schritt 24 Installing the undercarriage in trike format Montage des Fahrwerk für die Dreibein Version Slide a nose leg mounting block into the short straight section of the nose leg wire followed by the arm and another Stage 20 / Schritt 20 mounting block.
Page 7
Wot Trainer Instructions | Wot Trainer Anleitung Wot Trainer Instructions | Wot Trainer Anleitung Stage 29 / Schritt 29 Stage 34 / Schritt 34 Locate the slot in the fuselage for the fin and carefully trim Mark the positions of each servo's mounting holes, checking away the covering as shown.
Page 8
Wot Trainer Instructions | Wot Trainer Anleitung Wot Trainer Instructions | Wot Trainer Anleitung Stage 39 / Schritt 39 Stage 44 / Schritt 44 Now install the servo arm screw. Bolt the horn through the elevator into the retaining plate in other side.
Page 9
Wot Trainer Instructions | Wot Trainer Anleitung Wot Trainer Instructions | Wot Trainer Anleitung Stage 53 / Schritt 53 The Wot Trainer can be built for electric power (using steps 49-59) and the option EP installation pack, or I/C power (using steps 60-77) and the option I/C installation pack. Remove the battery tray from the fuselage by removing the Der WOT Trainer kann mit Elektroantrieb gebaut werden (Schritte 49-59), und das optionales screw in the middle of the tray.
Page 10
Wot Trainer Instructions | Wot Trainer Anleitung Wot Trainer Instructions | Wot Trainer Anleitung Stage 63 / Schritt 63 Stage 58 / Schritt 58 Now screw the spinner to the back plate, you may have Secure the engine to the mounts using the four bolts, washers and the nuts supplied.
Page 11
Wot Trainer Instructions | Wot Trainer Anleitung Wot Trainer Instructions | Wot Trainer Anleitung Stage 68 / Schritt 68 Stage 73 / Schritt 73 Tighten the screw in the connector at mid throttle position Secure the fuel tank to the battery tray with hook and loop then screw the arm to the throttle servo.
Page 12
Wot Trainer Instructions | Wot Trainer Anleitung Wot Trainer Instructions | Wot Trainer Anleitung Stage 77 / Schritt 77 Decals / Dekor Apply the decals as shown right. Remove the propeller, spinner backplate and take the spacer off from the backplate. Reinstall the backplate, prop, Befestigen Sie das Dekor, wie rechts gezeigt.
Page 13
Wot Trainer Instructions | Wot Trainer Anleitung Wot Trainer Instructions | Wot Trainer Anleitung Wot Trainer Instructions | Wot Trainer Anleitung Flying The Wot Trainer / Den Wot Trainer Fliegen Control Throws / Ruderausschläge For initial flights, we recommend the following control throws - each measured at the widest point of the surface: Elevator: 9~15mm up Rudder:...
Need help?
Do you have a question about the Chris Foss WOT Trainer A-CF001A and is the answer not in the manual?
Questions and answers