Page 2
SIGNAL bit Sice Rolling code. This allows to use the WHY EVO remote controls as a first installation in combination with one of our SICE Tech multifrequeuncy receiver. The further copies and its insertion on the receiver happen simply GROWN and directly.
Page 3
FIXED CODE DUPLICATING PROCEDURES licorice black magnolia white granade red sky blue cod. 4791010 cod. 4791011 cod. 4791012 cod. 4791013 IT IS RECOMMENDED: TO REALIZE A CORRECT DUPLICATION OF THE REMOTE CONTROLS, WE RECOMMEND TO BEST POSITION FOR THE FOLLOW THE PROCEDURES HERE BELOW TAKING CARE TO DISTANCE YOURSELF BY TOOL DUPLICATION THAT CAN GENERATE FREQUENCY TROUBLES AS: CORDLESS...
Page 4
ROLLING SIMPLE DUPLICATING PROCEDURES While pressing the button 1 of the “WHY EVO”, at the same time press 4 times the 2 button. Release both buttons. Now the WHY EVO WHITE LED will emit a short flash every 2 seconds. Place the original remote control to be programmed in front of the “WHY EVO”, at about 5 cm of distance (as shown in the picture).
Page 5
ROLLING COMPLEX DUPLICATING PROCEDURES While pressing the button 1 of the “WHY EVO”, at the same time press 4 times the 2 button. Release both buttons. Now the WHY EVO WHITE LED will emit a short flash every 2 seconds. Place the original remote control to be programmed in front of the “WHY EVO”, at about 5 cm of distance (as shown in the picture).
Page 6
ROLLING COMPLEX DUPLICATING PROCEDURES FAAC GENIUS 433 - 868 433 - 868 Attention: verify the programming remote control is a MASTER. Pressing whatever button, the LED has to emit a double flash rather than to switch on as a fixed light. While pressing the button 1 of the “WHY EVO”, at the same time press 4 times the 2 button.
Page 7
WHY EVO WHY EVO DUPLICATING PROCEDURES While pressing the button 1 of the “NEW WHY EVO”, at the same time press 4 times the 2 button. Release both buttons. Now the WHITE LED of “NEW WHY EVO” will emit a short flash every 2 seconds. Place the “SOURCE WHY EVO”...
SPECIAL PROCEDURES TO REACTIVATE THE ROLLING SICE TECH CODE INSERTED AS DEFAULT ON A BUTTON, PROCEED AS HERE BELOW: While pressing the button 1 of the WHY EVO, at the same time press 4 times the 2 button. Release both buttons. Now the WHITE LED “WHY EVO” will emit a short flash every 2 seconds.
Need help?
Do you have a question about the Why Evo 6.3 and is the answer not in the manual?
Questions and answers