Canon MX860 Service Manual page 12

Hide thumbs Also See for MX860:
Table of Contents

Advertisement

Ink tank not
[1684] U140 The following ink tank
recognized.
Ink tank not
[1682] U150 The following ink tank
recognized.
No ink (no raw
[1688] U163 The ink has run out.
ink).
Non-supported
[2002]
hub.
Document cover
---
not closed.
Paper jam in the
---
ADF.
No paper in the
---
ADF.
Paper in the ADF
---
is too long.
Duplex printing
---
not available with
the paper in the
ADF.
cannot be recognized.
(Applicable ink tank
icon)
cannot be recognized.
(Applicable ink tank
icon)
Replace the ink tank.
(Applicable ink tank
icon)
---
An unsupported USB
hub is connected.
Remove the hub.
---
The feeder cover is open.
Close cover and press
[OK].
---
Document in ADF. Redo
operation after checking
document in ADF and
pressing [OK].
---
No document in ADF.
Press [OK] and redo
operation after setting
document.
---
Document size is too
long. Redo operation
after checking document
on ADF and pressing
[OK].
---
Document size not
suitable for two-sided
scanning. Press [OK] to
cancel operation and
discharge document.
A non-supported ink tank (an
ink tank that is sold in a
different region from where the
machine was purchased) is
installed (the ink tank LED is
turned off). Install the
supported ink tanks.
A hardware error occurred in
an ink tank (the ink tank LED
is turned off). Replace the ink
tank(s).
Replace the empty ink tank(s),
and close the scanning unit
(cover).
Printing with an empty ink
tank can damage the machine.
To continue printing without
replacing the ink tank(s), press
the Stop button for 5 sec. or
longer to disable the function
to detect the remaining ink
amount. After the operation, it
is recorded in the machine that
the function to detect the
remaining ink amount was
disabled.
Remove the applicable USB
hub from the PictBridge (USB)
connector.
Close the document cover, and
press the OK button.
Remove the paper from the
ADF, and press the OK button.
Press the OK button to clear
the error.
Remove the paper from the
ADF, and press the OK button.
Remove the paper from the
ADF, and press the OK button.
9 / 64
- Ink tank
- Logic board
- Ink tank
- Logic board
- Ink tank
- Spur unit
- Logic board
- PictBridge board
- Logic board
- DF unit
- DF switch unit
- DF unit
- DF unit
- DF unit
- DF unit

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mx868

Table of Contents