Accessories; Before Use; Charging The Battery Pack - FLORABEST FALH 40-Li A1 Operation And Safety Notes

3. Make sure the delivery contents are complete
and free of any damage. If you find that
parts are missing or show damage do not
use the product but contact your dealer. Do
not use the product unless missing parts have
been delivered in addition or defective parts
have been replaced. Using an incomplete
or damaged product represents a hazard to
people and property.
4. Ensure that you have all the accessories and
tools needed for assembly and operation.
This also includes suitable personal protective
equipment.

Accessories

Q
To operate this product safely and correctly, the
following accessories, i. e. tools and attachments,
are necessary:
Oil suction gun with pinpoint tip
o
Sharpening set (chain file)
o
Suitable personal protective equipment
o
Accessories and tools are available through your
authorised dealer. When buying always consider
the technical requirements of this product (see
"Technical data").
If you are not certain, ask a qualified specialist and
get advice from your trusted dealer.
NOTE
This instruction manual contains information
u
and suggestions for several attachments and
their uses. The attachments mentioned are
not necessarily included in the shipment, but
are meant to indicate additional possibilities
for using this product.

Before use

Q
Attaching / removing the
Q
battery pack
Attaching the battery pack:
1. Align the battery pack
docking port and slide it onto it. Ensure it
5
clicks noticeably in place.
Removing the battery pack:
1. Press the release buttons
battery pack .
29
14 GB / IE / NI
to the battery
29
and remove the
31

Charging the battery pack

Q
NOTE
The battery pack
29
u
Charge the battery pack
ideally at least 60 minutes.
Always pull out the plug of the charger
u
the mains before removing or connecting the
battery pack to the charger.
29
Never charge the battery pack
u
ambient temperature is below 10 °C or above
40 °C.
Rest the charger
33
u
between successive charging sessions.
If no battery pack
29
u
and the charger is connected to mains,
33
the charging status LED
1. Connect the battery pack
charger .
33
2. Insert the mains plug into the socket. The
charging status LED
same time the green charging status LED
will extinguish. Once the battery pack
is completely charged, the green charging
status LED is lit continuously, indicating
34
that the charging process is complete. At the
same time the red charging status LED
extinguish.
3. Disconnect the charger
and remove the battery pack
charger.
4. Attach the battery pack
product (see "Attaching / removing the
battery pack").
Charging status LEDs
Green LED flashing Charger ready
Red LED Battery pack charging
continuously lit
Green LED Battery pack fully charged
continuously lit
Red and green Battery pack defect
LEDs flashing
Red and green LEDs Battery pack too cold or
continuously lit warm
comes partly charged.
prior to first use,
29
from
33
when the
29
for at least 15 minutes
is inserted into the charger
flashes green.
34
to the battery
29
lights up red, at the
35
34
29
will
35
from the mains
33
from the
29
back to the
29