Related Manuals for J. A. Roby ATMOSPHERE
Summary of Contents for J. A. Roby ATMOSPHERE
- Page 1 ATMOSPHERE WOOD STOVE Conforms to UL Std. 1482 Certified to ULC Std. S627 June 1 , 2013 Reviewed ATMOSPHERE 490, rue de l'Argon Quebec, Qc CANADA G2N 2C9 Phone: 418-849-8095 Fax : 418-849-0077 www.jaroby.com...
-
Page 2: Table Of Contents
TABLE OF CONTENTS WARNING........................3 NOTICE ......................... 5 ........................5 REOSOTE ATMOSPHERE-SPECIFICATIONS ................6 INSTALLATION ......................7 ..........8 ERTICAL INSTALLATION INSIDE A MASONRY CHIMNEY ................8 XTERIOR VERTICAL INSTALLATION ............9 ERTICAL INSTALLATION ON A CATHEDRAL ROOF ....................10 ROSS INSTALLATION .................. -
Page 3: Warning
WARNING Before installing, please take a few minutes to read this handbook. Keep it in a sure place and easily reachable for future references. If this appliance is not properly installed, it could cause fire damages to the property, injuries and death. To reduce fire hazards, follow instructions contained in this handbook. - Page 4 Do not burn wet or freshly cut wood. Do not use construction debris such as pieces of 2x4 or plywood. If the appliance starts to blush, it's because it is too charged. Do not add fuel. Immediately close the doors and the air intake of the appliance until everything becomes normal again.
-
Page 5: Notice
- Do not use the appliance when a glass is broken or damaged. - Do not build the fire too close of the glasses. - Keep the doors closed when using the appliance. - Do not connect the Atmosphere EPA with a chimney or a flue serving another heating appliance... -
Page 6: Atmosphere-Specifications
ATMOSPHERE-SPECIFICATIONS WITH OVEN WITHOUT OVEN OPTION Combustible WOOD WOOD 500ft to 2000ft 500ft to 2000ft Recommended surface (46.5m to 185.8m (46.58m to 185.8m Capacity 59 000 BTU/h 59 000 BTU/h Evacuation pipe diameter 6” (15.2cm) 6” (15.2cm) Chimney minimal height 12ft (3,7m) 12ft (3.7m) -
Page 7: Installation
INSTALLATION A good installation is extremely important for a safe and efficient use of your J.A. Roby Inc. appliance. If you doubt on the way to install the appliance correctly, seek for professional installation service. We suggest you to call masters fitters. 1. -
Page 8: Vertical Installation Inside A Masonry Chimney
ERTICAL INSTALLATION INSIDE A MASONRY CHIMNEY The Atmosphere EPA must be installed in accordance with the applicable local laws or the CAN/CSA - B365 ULC S635, ULC S640 norms. chimney, follow chimney manufacturer's instructions. XTERIOR VERTICAL INSTALLATION The Atmosphere EPA must be installed in accordance with the applicable local laws or the CAN/CSA - B365 ULC S635, ULC S640 norms. -
Page 9: Vertical Installation On A Cathedral Roof
ERTICAL INSTALLATION ON A CATHEDRAL ROOF The Atmosphere EPA must be installed in accordance with the applicable local laws or the CAN/CSA - B365 ULC S635, ULC S640 norms. For the chimney, follow the chimney manufacturer's instructions. -
Page 10: Cross Installation
ROSS INSTALLATION The Atmosphere EPA must be installed in accordance with the applicable local laws or the CAN/CSA - B365 ULC S635, ULC S640 norms. chimney, follow chimney manufacturer's instructions. ERTICAL INSTALLATION The Atmosphere EPA must be installed in accordance with the applicable local laws or the CAN/CSA - B365 ULC S635, ULC S640 norms. -
Page 11: Clearances
Due to its reduced clearances, this appliance occupies a minimum of space in the room where it is installed. No matter where you install it, the Atmosphere EPA will perfectly complete your decoration by its originality and its heat. It requires only 8 inches of clearance to the back and 12 inches of the sidewalls, with the addition of one heat shield, when the installation is made with a simple pipe. -
Page 12: Seating
SEATING You must install a fireproof plate under the appliance, which must exceed it of 18 inches to the front, of 8 inches to the sides and of 8 inches at the back. only non- combustible materials. Ex: (ceramics, marbles, granites) LIGHTING Now that you have completed the installation of the appliance according to the... -
Page 13: Fans And Thermodisc
FANS AND THERMODISC The 115 volts fans must be screwed with the grids beneath the air corridor. The thermo disc box must be screwed on the back of the corridor. Connect the thermo disc into the electrical outlet. When the appliance is in function, the heat reaching a temperature of F activates the thermo disc. -
Page 14: Preventive Measures And Maintenance
The Atmosphere is provided with an ashtray under the door. To empty the appliance, you just have to remove the cap made of steel (in the centre of the appliance) and to glide the ashes into the ashtray. -
Page 15: Interchangeable Parts List
INTERCHANGEABLE PARTS LIST • BRICKS • WOOL • CAP • PLATES USED TO RETAIN WOOL • PIPES • GLASSES • DOOR'S HANDLE • APPLIANCE'S DOOR • FANS • CORDS O ORDER PARTS PLEASE CONTACT YOUR AUTHORIZED RETAILER... -
Page 16: Installation Of The Firebricks
INSTALLATION OF THE FIREBRICKS To begin with, we take for granted that the screws used to fix the bricks supports of the back wall and of the side walls are partially screwed. Second, install the bricks on the side walls and the back wall: A(2), B(6), D(4), F(2) and tighten the screw to fix the bricks. -
Page 17: Warranty
WARRANTY STOVES & FIREPLACES J. A. ROBY LIMITED LIFE WARRANTY – WOOD BURNING STOVES & FIREPLACES J. A. ROBY’s warranty only applies to original buyer and is non-transferable. This warranty covers brand new products only, which have not been altered, modified nor repaired since shipment from factory. The products covered by this warranty must be manufactured after review date indicated at the bottom of page. - Page 18 1= Digital pictures required 2= Shipping cost are not covered outside CANADA Review oct. 2014...
Need help?
Do you have a question about the ATMOSPHERE and is the answer not in the manual?
Questions and answers