Friant MY-HITE FCNAHBT Assembly Instructions Manual
  1. Manuals
  2. Brands
  3. Friant Manuals
  4. Indoor Furnishing
  5. MY-HITE FCNAHBT
  6. Assembly instructions manual

Friant MY-HITE FCNAHBT Assembly Instructions Manual

Adjustable table, corner t leg base
Hide thumbs
1
2
3
4
5
6
7

Advertisement

Table of Contents

MY-HITE ADJUSTABLE TABLE
Corner T Leg Base
Model Number : FCNAHBT
Please Read Instructions Before Use
ALL
WORKSTYLES
ASSEMBLY INSTRUCTIONS
WELCOME

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MY-HITE FCNAHBT and is the answer not in the manual?

Questions and answers

Related Manuals for Friant MY-HITE FCNAHBT

Summary of Contents for Friant MY-HITE FCNAHBT

  • Page 1 MY-HITE ADJUSTABLE TABLE Corner T Leg Base Model Number : FCNAHBT Please Read Instructions Before Use WORKSTYLES ASSEMBLY INSTRUCTIONS WELCOME...

  • Page 2: Tools Needed

    7. If, after trouble shooting the problem persists, contact Customer Service for further assistance. Friant & Associates, LLC does not assume any responsibility for product that is altered in any way. IMPORTANT: When placing table in final location, be sure there is ample room for adjustment around ALL sides, and at the highest (50”)

  • Page 3: Parts List

    Parts List Installation Steps Step 1: Place worksurface finished side down on a blanket. PART# IMAGE NAME PIECES Step 2: Insert A side bracket into D crossbeam assembly. Repeat on other sides. Side Bracket WORKSURFACE Column Leg SIDE BRACKET Crossbeam CROSSBEAM Center Rails Control Panel...
  • Page 4 IMPORTANT: Make sure column legs are sitting perfectly flat against the Step 4: Use 4 socket button head bolts, M6*12mm to secure side bracket, column leg and worksurface crossbeam together as shown in detail. Step 7: Place all 3 leg assemblies on worksurface and insert E center rails into D crossbeams as shown.
  • Page 5 Step 8a: With option of post foot, as shown Step 11: Secure the F control panel in the Step 11a: With post foot option as shown Step 8: Secure E center rails to D below: desired location with N (2) truss head screws below: crossbeams with L (8) socket button head M5*20mm.
  • Page 6 Schematic view of the My-Hite wiring: Step 14: Turn table right side up, adjust the glides as necessary, and plug the power cord into a 110v outlet. Step 13a: With option of post foot, as shown Step 13: Install the H telescopic cover plates, below: leaving exit space for the electrical power cords, and secure to worksurface with N (8)
  • Page 7 3. Display will flash “999” and then show the set maximum height. E07, Signal Signal is E08, or Interruption interrupted between leg and computer friant.com 1980 West Avenue, 140th, San Leandro CA 94577 TEL: 510.535.51 13 FAX: 510.535.5237 http://www. July 2019...

Table of Contents