Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for UPPAbaby MESA
Summary of Contents for UPPAbaby MESA
- Page 1 From 1.8 - 15.9 kg (4-35 lbs)
-
Page 2: Table Of Contents
TABLE OF CONTENTS Read all instructions before use of the rear-facing car seat. Keep instruction book for future use. (Storage pocket located on underside of base.) BEFORE YOU BEGIN CERTIFICATION USE RECOMMENDATIONS REGISTRATION NOTICE OF EXPIRATION WARNINGS + GENERAL SAFETY INSTRUCTIONS REAR-FACING SEAT FEATURES OVERVIEW OF BASE OVERVIEW OF CARRIER... -
Page 3: Certification
HARNESS BUCKLE POSITIONING INFANT INSERT (RECOMMENDED 1.8-15.9 KG) This child restraint is certified for ADJUSTABLE HEAD SUPPORT + HARNESS POSITIONING aircraft use. UPPAbaby and Transport SECURING YOUR CHILD Canada Civil Aviation (TCCA) strongly PINCH TEST urge you to secure your child in a child... -
Page 4: Use Recommendations
Children should remain rear-facing for as long as possible. Please register your child restraint by filling out and UPPAbaby along with pediatricians and child passenger safety advocates sending the postage-paid registration card that came advise parents to keep their toddlers in rear-facing car seats until age 2, with your child restraint OR register online at: or until they reach maximum height and weight for their seat. - Page 5 It does not press on the child’s flesh occupied, since in a crash an unsecured child or push the child’s body into an unnatural position. restraint system may injure other occupants. UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book...
- Page 6 NEVER place carrier on beds, sofas, or other • DO NOT use this child restraint system if it has soft surfaces. been in a vehicle accident. UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book...
- Page 7 INSTEAD place a blanket over the restraint, unless approved and tested by UPPAbaby. child after being properly secured in the harness. Items not tested with this restraint could injure your child.
-
Page 8: Overview Of Base
Lap Belt Only (page/páge 22) Cinturón de Regazo Solamente LOCKING CLIP VEHICLE BELT LOCK-OFF (CLOSED) FRONT OF VEHICLE FRENTE DEL VEHÍCULO LEVEL WHEN NO RED VISIBLE LOWER ANCHOR ADJUSTMENT LEVEL ANGLE CONNECTOR STORAGE FOOT INDICATORS (2) UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book... -
Page 9: Overview Of Carrier
ANCHORS (2) INFANT INSERT LATCH RECOMMENDED PLATES (2) CROTCH BUCKLE BETWEEN 1.8-3.6 KG POSITIONS (2) (4-8 LBS) VEHICLE HARNESS HARNESS SEAT BELT HARNESS ADJUSTER ADJUSTER ADJUSTER GUIDES (2) STRAP HOLDER STRAP RELEASE UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book... -
Page 10: Choosing A Vehicle Seating Location
If the MESA does not install best in the rear center seating location, it is recommended to move to one of the outboard seating positions. -
Page 11: Overview Of Uas
559 mm (22 in) or if the seating position is not approved by the vehicle manufacturer for use with lower anchors then use the vehicle seat belt for installation. UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book... -
Page 12: Unsafe Vehicle Seat Belt Systems + Seating
Door mounted Inflatable be used. DO NOT use this child restraint with the following vehicle seats: Vehicle seats that face rear of the vehicle Vehicle seats that face side of the vehicle UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book... -
Page 13: Base Installation With Lower Anchors
(crease of seat) to tighten. If a tight installation cannot be achieved move the base to another seat position. NOTE: Check that the base is still properly leveled. UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book... -
Page 14: Leveling Base
STEP 1: Press the red button on the lower anchor connector while pulling the connector off the vehicle anchor STEP 2: Store lower anchor connectors in designated housing found on each side of the base. UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book... -
Page 15: Securing The Base With Vehicle Seat Belt
NOTE: Check that the base is still properly leveled. UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book... -
Page 16: Securing The Base (Lap Belt Only Installation)
NOTE: Before closing the lock-off door, make sure the vehicle seat belt has not slipped down into the belt path and is as close as possible to the topside of the lock-off where the door hinges. UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book... -
Page 17: Leveling The Carrier
LAP ONLY METHOD: No shoulder belt is used. This method applies NOTE: Check that the carrier is still to vehicle with no shoulder belt and aircraft. (proceed to pg. 33) properly leveled. UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book... -
Page 18: Installation With Locking Clip
STEP 3: Re-buckle the vehicle belt. NOTE: When in vehicle the carry handle must be in “vehicle use” position. The vehicle use position is the furthest forward locked position. UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book... -
Page 19: Safety Check
WHEN USED WITHOUT THE BASE. 25 mm (1 in) side to side at the belt path UPPAbaby and Transport Canada Civil Aviation (TCCA) • Belts are secure and untwisted. strongly recommend that children up to 18 kg (40 lbs) use a certified harnessed child restraint or other device approved •... -
Page 20: Harness Buckle Positioning
NOTE: Never use non-regulated products with this child restraint, unless approved by UPPAbaby. ADJUSTABLE HEAD SUPPORT + HARNESS POSITIONING STEP 1: Unbuckle the harness. -
Page 21: Securing Your Child
PINCH TEST HARNESS SHOULD BE SNUG. Pinch harness webbing at child’s shoulders. If you can pinch webbing, the harness is too loose and should be tightened. UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book... -
Page 22: Attaching Carrier To Base
These products have not been tested by STEP 2: Pull and hold carrier release button on back of the carrier. UPPAbaby and therefore are not approved for use with this child restraint. STEP 3: Lift carrier off base. -
Page 23: Important Checks
FITTING CARRIER TO STROLLER FRAME • This child restraint is for rear-facing use only. Prior to fitting MESA carrier to stroller frame, engage brake on stroller and remove toddler seat from frame. • The seat must be tightly installed in a forward-facing vehicle seat. -
Page 24: Fitting Adapters To Vista 2014 And Earlier Frame
NOTE: VISTA 2014 and earlier stroller models require adapters for use hubs with adapters on stroller. with the MESA. Please contact UPPAbaby Customer Service at (888) 502-5514 x235 for an adapter. STEP 2: Let carrier slide onto adapter posts. -
Page 25: Adjustable Head Support Padding Removal
STEP 4: Loosen padding from front end of carrier and free padding from around harness adjuster release button housing. STEP 5: Raise SIP to highest position and pull back padding panel. UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book... -
Page 26: Seat Padding Installation
STEP 3: Place second side tab into designated plastic slot and third side tab behind seat foam. Repeat on other side. STEP 4: Tuck top 2 tabs into designated slots and pull headrest adjuster tab through buttonhole. UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book... -
Page 27: Adjustable Head Support Padding Installation
STEP 3: Secure adjustable head support cover tightly around adjustable head support ears. STEP 8: Wrap padding around front lip and install 4 lower plastic tabs. STEP 9: Reconnect harness adjuster strap. UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book... -
Page 28: Cleaning
Model 1017-MSA-CA Version 5. All rights reserved. © 2018 UPPAbaby. UPPAbaby and all associated logos are trademarks. All product specifications are correct at time of print. UPPAbaby reserves the right to change anything at any time without prior notice. Color representation is as close as print processes allow. Not all colors available at all retailers. V5-122618...
Need help?
Do you have a question about the MESA and is the answer not in the manual?
Questions and answers