Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for UPPAbaby mesa
Summary of Contents for UPPAbaby mesa
- Page 1 From 4-35 lbs...
-
Page 2: Table Of Contents
TABLE OF CONTENTS Read all instructions before use of the rear-facing car seat. Keep instruction book for future use. (Storage pocket located on underside of base.) BEFORE YOU BEGIN CERTIFICATION USE RECOMMENDATIONS REGISTRATION NOTICE OF EXPIRATION WARNINGS + GENERAL SAFETY INSTRUCTIONS REAR-FACING SEAT FEATURES OVERVIEW OF BASE OVERVIEW OF CARRIER... -
Page 3: Certification
Motor Vehicle Safety Standards (FMVSS). LEVELING THE CARRIER DETERMINING BEST INSTALLATION METHOD This child restraint is certified for aircraft use. UPPAbaby and LAP/SHOULDER BELT STANDARD ROUTING METHOD the Federal Aviation Administration (FAA) strongly urge you to INSTALLATION WITH LOCKING CLIP... -
Page 4: Registration
CARRIER BASE installing this child restraint in a seating position UPPAbaby reserves the right to make design changes and improvements with side airbags. to any of our products as part of our commitment to innovation. UPPAbaby MESA Instruction Book... - Page 5 INSTEAD • NEVER hang strings on or over the carrier or place a blanket over the child after being properly attach to handle. secured in the harness. UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book...
- Page 6 1 in from the top of the supplied by other manufacturers with this child headrest when in its highest position. restraint, unless approved and tested by UPPAbaby. Items not tested with this restraint could injure DO NOT •...
-
Page 7: Overview Of Base
Lap Belt Only (page/páge 22) Cinturón de Regazo Solamente LOCKING CLIP VEHICLE BELT LOCK-OFF (CLOSED) FRONT OF VEHICLE FRENTE DEL VEHÍCULO LEVEL WHEN NO RED VISIBLE LOWER ANCHOR CONNECTOR ADJUSTMENT LEVEL ANGLE FOOT INDICATORS (2) STORAGE UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book... -
Page 8: Product Overview
HARNESS BUCKLE ANCHORS (2) INFANT INSERT LATCH (RECOMMENDED PLATES (2) CROTCH BUCKLE BETWEEN 4-8 LBS) POSITIONS (2) HARNESS VEHICLE HARNESS ADJUSTER SEAT BELT ADJUSTER RELEASE GUIDES (2) HARNESS ADJUSTER STRAP STRAP HOLDER UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book... -
Page 9: Choosing A Vehicle Seating Location
If the MESA does not install best in the rear center seating location, it is recommended to move to one of the outboard seating positions. -
Page 10: Overview Of Latch
If spacing between the lower anchors is greater than 22 in or if the seating position is not approved by the vehicle manufacturer then use the vehicle seat belt for installation. UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book... -
Page 11: Unsafe Vehicle Seat Belt Systems + Seating
Door mounted Inflatable DO NOT use this child restraint with the following vehicle seats: Vehicle seats that face rear of the vehicle Vehicle seats that face side of the vehicle UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book... -
Page 12: Base Installation With Lower Anchors
STEP 1: Press the red button on the lower anchor connector while downward push is discontinued. pulling the connector off the vehicle anchor STEP 2: Store lower anchor connectors in designated housing found on each side of the base. UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book... -
Page 13: Leveling Base
If movement is more than 1 in, twist the buckle and then fasten the seat belt to help secure fit. Securing the Base (Lap Belt Only Installation)–pg. 24, steps 4B-6B. UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book... -
Page 14: Securing The Base (Lap Belt Only Installation)
NOTE: Check that the base doesn’t move more than 1 in side to side at the belt path. If movement is more than 1 in, twist the buckle and then fasten the seat belt to help secure fit. UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book... -
Page 15: Leveling The Carrier
(proceed to pg. 27) LAP ONLY METHOD: No shoulder belt is used. This method applies to vehicle with no shoulder belt and aircraft. (proceed to pg. 29) UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book... -
Page 16: Installation With Locking Clip
• Angle is correct when the vehicle is parked on level ground and the red line on the carrier is level to the vehicle floor • Seating position is permitted by both UPPAbaby and your vehicle manufacturer for use with the type of Vehicle Seat Belt. -
Page 17: Aircraft Installation
The crotch belt and buckle has two use positions. Always position the buckle and crotch strap in the slot closest to the child. If the child is on top of the UPPAbaby and the Federal Aviation Administration (FAA) buckle in the inner position, then adjust the buckle to the outer position. -
Page 18: Infant Insert (Recommended 4-8 Lbs)
STEP 2: Open the retainer clip, NOTE: Never use non-regulated products with unbuckle the harness, and tuck this child restraint, unless approved by UPPAbaby. the latch plates into the side pockets to hold harness open. STEP 3: Place infant in child restraint... -
Page 19: Pinch Test
If you can pinch STEP 1: Pull and hold carrier release webbing, the harness is too button on back of the carrier. loose and should be tightened. STEP 2: Lift carrier off base. UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book... -
Page 20: Hide-Away Canopy
These products have not been • Always check the tightness indicator is green after each use. tested by UPPAbaby and therefore are not approved for • Always secure an unoccupied child restraint; in a crash an unsecured infant car seat may injure occupants in your vehicle. -
Page 21: Fitting Carrier To Stroller Frame
NOTE: VISTA 2014 and earlier stroller models require adapters for STEP 1: With carrier facing stroller use with the MESA. Please contact UPPAbaby Customer Service at handle, align carrier handle hubs 781.413.3030 for your free adapter. -
Page 22: Fitting Carrier To Vista 2014 And Earlier Frame Adapters
STEP 3: Pull SIP padding down from bottom and release. STEP 1: Engage and hold the stroller release button on the top of the carry handle. STEP 2: Lift the carrier off the adapters on stroller frame. UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book... -
Page 23: Seat Padding Removal
STEP 4: Loosen padding from front end of carrier and free padding from around harness adjuster release button housing. STEP 5: Raise SIP to highest position and pull back padding panel. UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book... -
Page 24: Seat Padding Installation
STEP 4: Feed buckle through buttonhole in seat padding. STEP 10: Reconnect harness adjuster strap. STEP 5: Install buckle cover tucking tabs through buttonhole. STEP 6: Raise the SIP and place buckle in harness holder pockets. UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book... -
Page 25: Sip Padding Installation
CLEANING BUCKLE AND LOWER ANCHOR CONNECTOR HARDWARE NOTE: Buckle should fasten with a “click” if not, rinse under warm running water. DO NOT use detergents or lubricants. UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book... -
Page 26: Limited Warranty
Conditions may vary. UPPAbaby will not ship replacement or repair parts out of the country of purchase. UPPAbaby will provide replacement parts or conduct repairs as determined fitting by the company. - Page 27 All rights reserved. © 2014 UPPAbaby. UPPAbaby and all associated logos are trademarks. All product specifications are correct at time of print. UPPAbaby reserves the right to change anything at any time without prior notice. Color representation is as close as print processes allow. Not all colors available at all retailers.
Need help?
Do you have a question about the mesa and is the answer not in the manual?
Questions and answers