Advertisement
INTUITY AUDIX LX Release 1.0
Centrex Integration
6
Setting the 202T Modem
202T Modem Types
202T Modem Types
You can install either one of the following 202T modem types with the I
AUDIX system:
However, the modem at the service provider switch may be different, though the
commonly-supported modems at the service provider switch include the following:
When you install at Motorola 202T modem with the Intuity AUDIX system, the
modem at the service provider switch must always be set to the default options. If
the Intuity AUDIX modem is an AT&T Dataphone 202T, the modem options at the
service provider switch may differ. See
Switch on page
The manufacturer's name appears on the faceplate of the unit.
Setting Options for the 202T Motorola
Modem
The Motorola 202T modem contains 14 jumpers that must be correctly set. Use
this procedure to set the jumpers.
1. To remove the top cover from the Motorola 202T modem, complete the
Motorola 202T modem
AT&T Dataphone 202T modem
General DataCom 202T modem
Rexon 202T modem
NEC 202T modem
6-11.
following Steps a through f:
NOTE:
Installers in Canada may need to use a screwdriver to remove a
screw through the top rear panel or to remove tabs located between
the cover latch and the bottom plate.
a. Turn the modem on its side.
b. Place your thumbs on the blue tabs and your fingers on the edge of
the cover
(Figure
Modem Settings for the Service Provider
6-1, View 1).
Issue 1
May 2002
Page 6-2
™
NTUITY
Advertisement
