Table of Contents
Advertisement
INSTALLATION
1 Installing the cross bar
Before installing the Cross Bar
( E ) to the junction box, Screw
the two Back Plate Screws ( B )
to the Cross Bar ( E ) first.
Line up the holes on the cross
bar with the holes on your
junction box. Using the two
Mounting Screws ( F ) attach
the Cross Bar ( E ) to your
junction box.
Keep the Bar screwed with Back
Plate Screw ( B ) in the horizontal
direction then fix it tightly.
WARNING: Risk of electric shock. Disconnect power at fuse or circuit breaker
2 Wiring the Light Fixture
CAUTION: Do not cut any wires with factory installed wire connectors or
remove the wire connectors.
Connect the light fixture wires to the junction box wires with Wire Nut ( D ).The wire should
pass through the Sponge foam ( I ).
White to white
Black to black
Green ground wire to house ground
Note: Make sure the polarity is correct.
5
before installing or servicing.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the AEC-326KA2-AC14W and is the answer not in the manual?
Questions and answers
the red wire is for what the black wire is for what two white wires are for what these wires are off the motion detecter
the red wire is for what? the black wire is for what? two white wires are for what?