Advertisement
Quick Links
Flashing Beacon Kit
CT or LT Series Turf Mowers
Model No. 02901—Serial No. 316000001 and Up
Preparing the Machine
1. Move the machine to a level surface, set the parking
brake, shut off the engine, and remove the key.
2. Open the engine cover.
3. Disconnect the battery as follows:
WARNING
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead compounds,
chemicals known to the State of California
to cause cancer and reproductive harm.
Wash hands after handling.
A. Disconnect the negative (black) ground cable
from the negative (-) battery post.
WARNING
Incorrect battery cable routing could
damage the machine and cables, causing
sparks. Sparks can cause the battery gases
to explode, resulting in personal injury.
• Always disconnect the negative (black)
battery cable before disconnecting the
positive (red) cable.
• Always connect the positive (red)
battery cable before connecting the
negative (black) cable.
© 2016—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Installing the Kit
Register at www.Toro.com.
WARNING
Battery terminals or metal tools could
short against metal machine components,
causing sparks. Sparks can cause the
battery gases to explode, resulting in
personal injury.
• When disconnecting or connecting
the battery, do not allow the battery
terminals to touch any metal parts of
the machine.
• Do not allow metal tools to short
between the battery terminals and
metal parts of the machine.
B. Disconnect the positive (red) cable from the
positive (+) battery post.
4. Remove the bulkhead to enable access to the main
wiring loom by removing the 4 screws.
1. Ensure that the ROPS pivot bolts and clamp bolts are
in place and tight.
2. Remove the nut, bolt, and washers from the ROPS on
the right side of the machine and discard the nut and
bolt; refer to
Figure
Note: Retain the washers.
Figure 1
1. Bolt (discard)
2. Washer (retain)
Original Instructions (EN)
All Rights Reserved *3401-328* A
Printed in the UK
Form No. 3401-328 Rev A
Installation Instructions
1.
3. Nut (discard)
Advertisement
Related Manuals for Toro CT Series
Summary of Contents for Toro CT Series
- Page 1 (black) cable. Figure 1 1. Bolt (discard) 3. Nut (discard) 2. Washer (retain) © 2016—The Toro® Company Register at www.Toro.com. Original Instructions (EN) All Rights Reserved *3401-328* A 8111 Lyndale Avenue South Printed in the UK...
- Page 2 3. Align the hole in the beacon bracket with the hole in the ROPS and install the new bolt with an existing washer (Figure Figure 4 1. Wing nut 7. Plug the beacon onto the top of the beacon stand (Figure Figure 2 1.
- Page 3 11. Insert a cable tie through each of the 2 holes in the 4. Install the negative (black) ground cable to the negative beacon bracket (Figure 7), and secure the cable. (-) battery terminal. 5. Lower and latch the engine cover. Operation Using the Beacon To turn on the beacon, press the bottom of the switch.
- Page 4 Countries Other than the United States or Canada Customers should contact their Toro Distributor (Dealer) to obtain guarantee policies for your country, province, or state. If for any reason you are dissatisfied with your Distributor's service or have difficulty obtaining guarantee information, contact the Toro importer. If all other remedies fail, you may contact us at Toro Warranty Company.