Port Menu⎯Setting Up Logical Ethernet Output Ports - Motorola OM 1000 Installation And Operation Manual

4-28 Setup and Operation
PORT Menu⎯Setting Up Logical Ethernet Output Ports
Each logical Ethernet output port can transmit data via either singlecast, broadcast, or
multicast. The user defines the destination UDP port and a destination IP address. If the
address is a class D, multicast IP address, the user should verify that the Time-To-Live (TTL)
setting is correct. Figure 4-18 illustrates setting up a logical Ethernet output port.
Figure 4-18
Setting up logical Ethernet output port
Main menu Port (logical)
Port setup
PORT
selection menu
To setup a logical Ethernet output port:
1
Select the PORT option on the MAIN menu.
2
Select a logical Ethernet output port (1 through 16) at the PORT ##: prompt. If setting
up a new output port, select DST-UDP and specify a destination UDP port number using the
Logical Ethernet Output Port menu (Figure 4-19).
3
Select the MORE option and then press ENT to display the Logical Ethernet Destination IP
Address menu (Figure 4-20).
4
Select DST-IP and enter a destination IP address (singlecast, broadcast, or multicast IP
address).
OM 1000 Installation and Operation Manual
1
Port
through
selection
16
Physical
interface
Operation
ULCKD
state
LCKD
OFF
Port
IN
mode
OUT
Back to
UP
main menu
To Destination
IP menu
MORE
(disabled if not OUT)
DST-UDP
XXXXX
port #
Active only if
COMMIT
changes are
made to Port
configuration
Destination
DST-IP XXX.XXX.XXX.XXX
IP menu
MPEG/UDP
Back to
Port setup menu
1
to
7
UP