Radio Tuning; Manual Tuning; Automatic Tuning - MG ZR Series Owner's Manual

TUNING

Radio Tuning

BND.TS TRAF.RDS 1 2 3 4
RPT
2 1
AS0046

Manual tuning

NOTE: Manual tuning on the FM waveband can only be undertaken
with RDS and PTY deactivated.
If you know the frequency of the radio station you are seeking, or
you need to select a radio station that is too weak to be found by
automatic tuning, use manual tuning, as follows:
1. Press the waveband selector (2) to select the desired waveband
or memory bank.
2. If necessary, press and hold the RDS button (1) until RDS is
deactivated (the RDS indicator disappears from the display),
and disable PTY (see 'Switching PTY on and off', page 106).
3. Operate one of the tuning controls (3) until the desired
frequency has been reached.
102
Radio Tuning
Fast manual tuning: By keeping either of the
depressed, the waveband is scanned rapidly down or up until the
control is released.
3

Automatic tuning

Select the required waveband, then briefly press the
SRC
tuning control (3).
DMS
The radio searches the frequency range (up or down depending
MENU
upon which tuning control was pressed) for a radio station of
acceptable strength. Once a suitable station is found, the search
5 6 AUDIO X-BASS
MIX
stops. To continue searching, press one of the tuning controls
again.
4
Tuning sensitivity
The sensitivity with which automatic tuning takes place can be
adjusted. For example, the tuner can be configured to enable it to
respond only to those radio stations which provide strong
reception or, alternatively, to radio stations with weaker
transmissions as well.
1. Press the MENU control (4).
2. Press the
3. Press the
4. Press the MENU button to store your selection.
NOTE: Different tuning sensitivities can be set for FM and MW/LW.
or controls (3) until 'SENS' appears in the
display.
controls (3) to set the required sensitivity
('SENS LO1' indicates that the tuner is at its lowest sensitivity
setting and will tune to strong signals only, while 'SENS HI6
indicates that the tuner is most sensitive). If 'SENS LO' has
been selected, the 'lo' indicator illuminates in the display.
tuning controls
or