S monitor Introduction and Features Introduction Thank you for purchasing the S monitor personal monitor system from Samson Audio! S monitor provides an elegant solution for personal monitoring, either on stage or in the studio. The S monitor is a specially designed headphone amplifier that allows you to mix the balance between the signals from your microphone together with a stereo source.
S monitor Front and Rear Panel Layout STEREO THRU - 1/4-inch TRS (TIP/ DC POWER INPUT - Connect the sup- RING/SLEEVE) connector to output plied power adapter here. main stereo signal. POWER LED - Red LED will illuminate when power is on indicating the S mon- MIC INPUT - Connect any dynamic itor is ready for operation.
Operating the S monitor Setting Up the S monitor The basic procedure for setting up and using your S monitor is simple and takes only a few minutes. Remove all packing materials (save them in case of need for future service) and check to make sure that you remove the supplied AC power adapter.
Page 6
Operating the S monitor Connecting a Stereo Monitor Signal Now you’re ready to connect the stereo monitor feed from your main mixer. You can use the headphone output from your mixer, one or two of your mixers AUX/MONITOR sends, or any stereo line level source to feed the STEREO monitor input. Use a standard 1/4-inch TRS (Tip/Ring/Sleeve)(Tip=L;...
Operating the S monitor Typical Set-up The diagram below shows a typical set-up for a small band using three S monitor mixer/headphone amplifiers for a sophisticated personal headphone monitoring system. The vocalist’s microphone is connected to the MIC input and then passed through to the main mixer using the MIC THRU output.
Need help?
Do you have a question about the S-Monitor and is the answer not in the manual?
Questions and answers