Samsung AN026JSKLKN Series Installation Manual page 13

Electric wiring
1 . Remove the 4 screws on the electrical component box and open the cover plate .
Screw
Electrical component box
[✴✴026✴✴]
2 . Connect the cables correctly as seen in the picture .
- Fix the cables with a cable tie .
3 . Connect the cable to the terminal board with a compressed ring terminal .
❇ ❇ Fix the screws in the electrical component box with designated torque referring to the table .
Power Cable
Communication Cable
❇ 1 N•m=10 kgf•cm
• Do not wash the heat exchange element . It may decrease the efficiency .
• The unit should be installed in accordance with the national Electrical regulations . Ensure that the national
CAUtIoN
safety code requirements have been followed for the main supply circuit .
F4
Connect to a wired remote controller
F3
Fixing part of electrical wires
Connect to power supply wire
Compressed ring terminal
Cable
Recommended size
ENGLISH-13
Maintenance cover
Electrical component box
[✴✴035/050/080/100✴✴]
M4
M3 . 5
Screw
Cable fixation
Tightening torque (kgf•cm)
12 . 0 ~ 18 . 0
8 . 0 ~ 12 . 0