Installation; Location - Miele KFN 37232 iD Operating And Installation Instructions

Installation

Installation

Location


Danger of damage and injury
due to the refrigeration appliance tip-
ping over.
This refrigeration appliance must be
built in, otherwise it could tip over.
Keep the appliance door(s) shut until
the refrigeration appliance has been
built in and secured in its housing in
accordance with these operating and
installation instructions.

Fire risk and risk of damage from
appliances which give off heat.
Appliances which give off heat can
catch fire and set fire to the refrigera-
tion appliance.
This refrigeration appliance must not
be installed underneath a hob.
This appliance should be installed in a
dry, well-ventilated room.
When deciding where to install your re-
frigeration appliance, please bear in
mind that it will use more energy if in-
stalled near to a heater, a cooker or
other appliance that gives off heat. Dir-
ect sunlight should also be avoided.
The higher the room temperature, the
longer the compressor runs and the
higher the energy consumption is.
When installing the refrigeration appli-
ance, please note:
– The socket must be easily accessible
in an emergency, not concealed be-
hind the appliance.
52
– The plug and power cable must not
touch the rear of the refrigeration ap-
pliance as they could be damaged by
vibrations from the appliance.
– Do not plug in other appliances be-
hind this refrigeration appliance.

Risk of damage due to high hu-
midity.
In environments with high humidity,
condensation can build up on ex-
ternal panels of the refrigeration ap-
pliance, which can cause corrosion.
Install the refrigeration appliance in a
dry and/or air-conditioned room with
sufficient ventilation.
After installation, make sure that the
appliance doors close properly, the
ventilation gaps are not covered and
that the appliance has been installed
in accordance with these operating
and installation instructions.