Error Code; Error Code Details - Canon imageCLASS MF269dw Service Manual

Error Code

Error Code Details

E000-0000--
Detection Description
Remedy
E001-0000--
Detection Description
Remedy
E003-0000--
Detection Description
Remedy
E004-0000--
Detection Description
Remedy
E015-0001--
Detection Description
Remedy
E066-0000--
Detection Description
Remedy
E100-0001--
Detection Description
Remedy
Fixing temperature control startup failure
Temperature of the Fixing Unit does not reach the specified temperature within the specified period
of time.
1. Check the harness/connector of the Fixing Unit.
2. Replace the Fixing Film Unit.
3. Replace the Fixing Unit.
4. Replace the Engine Controller PCB.
Abnormal high temperature of the Fixing Unit
It was detected that the temperature of the Fixing Unit was abnormally high.
1. Check the harness/connector of the Fixing Unit.
2. Replace the Fixing Film Unit.
3. Replace the Fixing Unit.
4. Replace the Engine Controller PCB.
Abnormal low temperature of the Fixing Assembly
It was detected that the temperature of the Fixing Assembly was abnormally low.
1. Check the harness/connector of the Fixing Unit.
2. Replace the Fixing Film Unit.
3. Replace the Fixing Unit.
4. Replace the Engine Controller PCB.
Fixing Heater drive circuit error
A frequency failure was detected in the Fixing Assembly.
1. Check the harness/connector of the Fixing Unit.
2. Replace the Fixing Film Unit.
3. Replace the Fixing Unit.
4. Replace the Engine Controller PCB.
Developing Disengagement error
A developing disengagement error was detected.
1. Check the harness/connector between the Developing Disengagement Solenoid and the Engine
Controller PCB.
2. Check the harness/connector between the Main Motor and the Engine Controller PCB.
3. Replace the Developing Disengagement Solenoid.
4. Replace the Motor PCB.
5. Replace the Engine Controller PCB.
Environment Sensor error
An error in the Environment Sensor was detected.
1. Check the harness/connector between the Environment/Pickup Sensor PCB and the DC
Controller PCB.
2. Replace the Environment/Pickup Sensor PCB.
3. Replace the Engine Controller PCB.
BD error
BD error was detected.
1. Check the harness/connector between the Laser Scanner Unit and the Engine Controller PCB.
2. Replace the Laser Scanner Unit.
3. Replace the Engine Controller PCB.
238
7. Error/Jam/Alarm