Table of Contents
Advertisement
Available languages
Available languages
Assembly
WARNING
Do not plug in your vacuum until you are familiar with all instructions and operating procedures.
1
Position the handle so the lower tab is
facing the back of the vacuum. Insert
the handle into the base and push until
you hear it lock into place.
3
Attach TurboBrush®
Tool holder to handle by
lining up the hole in the
TurboBrush holder with
the indent on the handle,
and snapping into place.
2
Wrap the power cord around Upper and
Lower Cord Wraps.
4
TurboBrush
Tool
Attach tools by inserting them onto the on-unit
tool holders.
Crevice Tool
www.BISSELL.com
Dusting Brush
5
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the PowerForce Compact Turbo 2690 Series and is the answer not in the manual?
Questions and answers
Boswell power force compact turbo vacuum will not start
The Bissell PowerForce Compact Turbo 2690 Series vacuum may not start due to the following possible causes:
1. The power cord is not plugged in – Ensure the plug is securely connected to an electrical outlet.
2. A blown fuse or tripped circuit breaker – Check and replace the fuse or reset the circuit breaker if needed.
3. The dirt tank is full – Empty the dirt tank.
4. A dirty filter – Inspect the filter and clean or remove any dirt.
5. The hose is not securely connected – Ensure the hose is properly attached at both ends.
6. The dirt tank is not correctly positioned – Make sure the dirt tank is fully inserted and latched.
7. A vacuum path obstruction – Check for blockages in the air passage or intake area.
Following these steps should help resolve the issue.
This answer is automatically generated