Advertisement
Available languages
Available languages
CHANGING
MOTOR VOLTAGE
MAKE CERTAIN THE DUST COLLECTOR IS
DISCONNECTED
FROM THE POWER SOURCE.
The motor supplied with your Dust Collector is a dual
voltage 115/230-volt, single-phase
motor. It is shipped
wired for 115-volt application.
If you choose 230-volt to
operate your machine, the following instructions
must
be followed.
If you are unsure of electrical connections or codes,
contact a certified electrician.
All local and state codes
must be followed.
Refer to GROUNDING
INSTRUCTION section before
proceeding:
1. DISCONNECT
THE DUST COLLECTOR
FROM
THE POWER SOURCE.
2.
Remove the switch box cover.
3.
The motor has four beads. Reconnect the motor
leads for chosen voltage, as shown in the wire
diagram.
See figure 11.
4.
The START/STOP switch is a double pole switch.
No changes are required for 120/240 volt operation.
5.
Replace the plug with the correct plug with ground
for voltage required.
The new plug must meet all
local and state electrical codes.
6.
Reassemble switch box cover.
1 15 VOLT
CONNECTION
4
4
230 VOLT CONNECTION
Fig. 11
14
Advertisement
