Step 7: Hw Config; Integrating The Gsd File In Step 7; Assigning Parameters For Communication Between The Hmi Device And The Controller - Siemens Second Wind Function Manual

4.3

STEP 7: HW Config

Procedure in STEP 7 HW Config
When you have created a STEP 7 project in the SIMATIC Manager, configure the desired
F-CPU and a PROFINET connection in the hardware configuration "HW Config".
Then insert a Mobile Panel 277F IWLAN in the configuration from the hardware catalog of
the HW Config by dragging it to the PROFINET connection in the station window via
Drag&Drop.
Configure the communication between the HMI device and the F-CPU in the properties of
the HMI device.
4.3.1

Integrating the GSD file in STEP 7

If the HMI device is not listed in the hardware catalog of HW Config, you need to integrate
the valid GSD files for the HMI device in the STEP 7 database.
The GSD files are available on the documentation CD or in the Internet at the following
address:
"http://www.siemens.com/automation/support"
Note
At installation of WinCC flexible, the GSD files supplied with WinCC flexible are automatically
integrated in STEP 7.
4.3.2 Assigning parameters for communication between the HMI device and the
controller
Introduction
If you select the HMI device in the HW Config, the following modules are displayed:
● mobile277fiwlan
● Mobile277Standard_IO
● Mobile277Failsafe_IO
Object properties of the module "Mobile277Failsafe_IO"
The parameters for fail-safe operation are configured in the object properties of the
Mobile277Failsafe_IO module. You can only change this parameter after you have entered a
password for the safety program.
You can find additional information about access protection in the manual
"S7 Distributed Safety Configuring and Programming".
Fail-safe operation of the Mobile Panel 277F IWLAN
Function Manual, 08/2008, 6AV6691-1FQ01-2AB0
Configuration
4.3 STEP 7: HW Config
55