Advertisement
Advertisement
Table of Contents
Related Manuals for Projecta DC20
Summary of Contents for Projecta DC20
- Page 1 P/No. DC20...
- Page 2 WARNING Explosive gases may escape from the battery during charging. Prevent flames and sparks and provide adequate ventilation. Before charging, read the instructions. FOR CHARGING 12 VOLT LEAD ACID BATTERIES ONLY. Do not attempt to charge non-rechargeable batteries. Never charge a frozen battery. Corrosive substances may escape from the battery during charging and damage delicate surfaces.
- Page 3 IGNITION CONNECTION The DC20 can be wired to the vehicle’s ignition allowing it to operate only when the ignition is turned on. Alternatively you can connect the ignition and input terminals for continuous operation.
-
Page 4: Specifications
SPECIFICATIONS... -
Page 5: Product Overview
PRODUCT OVERVIEW... -
Page 6: Installation - Mounting
“Electrical System Memory Protector” be used. 2. Mount the DC20 using the ‘side extrusions’ of the unit. Mount to a flat surface in a convenient location as close to the output (auxiliary) battery as possible. The DC20 enclosure is weatherproof, but should be protected from rain and submersion. - Page 7 This can be done in two ways: a) Connect ignition terminal to the vehicle’s ignition. The DC20 will operate only when the vehicle’s ignition is turned on. Fit a 3A fuse to the cable as close as possible to the vehicle’s ignition.
- Page 8 Fault LED RED: A fault has been detected. Check internal fuses are intact and wiring to the DC20 is correct. If fault LED is still on the unit is damaged. Do not attempt to repair.
-
Page 9: Troubleshooting (Faq)
Q. I have connected the charger properly but the ‘INPUT LED’ does not come on? A. The DC20 is designed to charge from a starter battery that has as little as 9V. If the voltage is below 9V, start the vehicle to allow the alternator to begin charging the battery or alternatively charge the battery using a suitable battery charger. - Page 10 Q. Why does the ‘FULLY CHARGED’ LED come on straight away? A. There are three possible reasons why the ‘FULLY CHARGED’ LED may come on straight away. 1. The battery is fully charged. 2. The battery has taken a surface charge. 3.
- Page 12 Distributed by AUSTRALIA Brown & Watson International Pty Ltd Knoxfield, Victoria 3180 Telephone (03) 9730 6000 Facsimile (03) 9730 6050 National Toll Free 1800 113 443 NEW ZEALAND Narva New Zealand Ltd 22–24 Olive Road PO Box 12556 Penrose Auckland, New Zealand Telephone (09) 525 4575 IS176...
Need help?
Do you have a question about the DC20 and is the answer not in the manual?
Questions and answers