Spare Parts - Bosch Worcester Greenstar Utility 32/50 Installation, Commissioning And Servicing Instruction Manual

Inspection and maintenance
Refit panels
1. Locate the bottom edge of front panel onto the supporting ledge on
the baseplate.
2. Locate the ball studs into the ball catches [1] and press the top edge
of the front in to secure.
3. Locate the rear of the top panel onto the tabs and press down firmly
to secure the ball stud catches [2].
Always apply pressure at the edges of the appliance panels when
securing to avoid accidental damage.
2
1
2
1
Fig. 61
After service handover
▶ Make a note of the date of any water treatment.
▶ Set the controls back to the users requirements.
▶ Complete the service interval record at the back of this manual and a
CD11 or an equivalent form.
▶ If the appliance is unused and exposed to freezing conditions;
– shut off all the mains supplies.
– Isolate the appliance and drain the system and appliance,
including the secondary heat exchanger.
7.6

Spare parts

WARNING: Mains supplies - Isolate the appliance
▶ Turn off the oil supply and isolate the mains electrical
supply before starting any work and observe all
relevant safety precautions.
▶ Drain the appliance/system where necessary and
protect any electrical equipment from water ingress
during component replacement.
Only use Worcester, Bosch Group original spare parts
with this appliance. Non Worcester, Bosch Group spare
parts will invalidate the guarantee (if applicable) and any
warranty.
▶ A comprehensive list of appliance spares can be
found in the Spares Booklet.
▶ Alternatively refer to the website at
www.worcesterbosch.co.uk/spares
40
3
2
1
Greenstar Utility ErP - 6 720 821 751 (2018/04)